Table of Contents
Advertisement
Identifying the Parts
Rear panel
VOLTAGE
SELECTOR
240V aces
Cet 230V
[16] INPUT CH1/CH2 terminal (XLR-3-31 connector)
Balanced-type terminals for input of ch1 and ch2.
[17] INPUT CH1/CH2 terminal (phone jack)
Phone jacks for input of ch1 and ch2.
OUTPUT CH1/CH2 terminal (XLR-3-32 connector)
Balanced-type terminals for output of ch1 and ch2
OUTPUT CH1/CH2 terminal (phone jack)
Phone jacks for output of ch1 and ch2.
When both XLR connectors and phone jacks are used,
the equipment connected to the phone jacks will be
given a priority.
MIDI IN terminal (DIN 5-pin)
Input terminal for the MIDI signal.
A commercially
available MIDI cable can be connected between this
terminal and a MIDI OUT (or THRU) terminal of another
MIDI equipment.
|21| MIDI OUT terminal (DIN 5-pin)
Outputs the MIDI signal generated in this unit.
[22] MIDI THRU terminal (DIN 5-pin)
This terminal directly outputs the MID! signal received
from the MIDI IN terminal.
A commercially available
MIDI cable can be connected between this terminal and
a MIDI IN terminal of another MIDI equipment.
8
GETTING STARTED
6®
e0
23| REMOTE IN terminal (D-Sub 9-pin)
The terminal to which an optional remote commander is
connected. The remote commander enables you to
remotely control the unit.
REMOTE THRU terminal (D-Sub 9-pin)
This terminal directly outputs the signal received from
an optional commander through the REMOTE IN
terminal. This terminal should be connected to a
REMOTE IN terminal of any effector of the DPS series.
[25] AC IN jack
Use the supplied power cord to plug in a power outlet.
[26] Voltage selector
(only for UK and European model)
Set the voltage selector to the correct position before
connecting the AC power cord to a wall outlet.
Advertisement
Table of Contents
