Table of Contents
Advertisement
INSTALLATION - CONTINUED
NOTE
When installing the mid-static ducted indoor unit vertically,
the vertical drain pan (in the conversion kit) must be in-
stalled.
If the conversion kit / vertical drain pan is not used, water will leak and
cause a slippery surface condition and/or water damage to walls.
The unit is shipped with refrigerant and the service valves
closed.
Do not open service valves on the unit until all
non-condensibles have been removed from the piping system
and authorization to do so has been obtained from the com-
missioning agent.
There is a risk of refrigerant contamination, refrigerant loss and equip-
ment damage.
WIRING
DANGER
High voltage electricity is required to operate this system.
Follow the National Electrical Codes and these instructions
when wiring.
Improper connections and inadequate grounding can cause accidental
injury or death.
Always ground the unit following local, state, and National
Electrical Codes.
WARNING
The information contained in this manual is intended for use
familiar with the U.S. National Electric Code (NEC) who is
equipped with the proper tools and test instruments.
Failure to carefully read and follow all instructions in this manual can
result in personal injury or death.
All electric work must be performed by a licensed electrician
and conform to local building codes or, in the absence of
local codes, with the National Electrical Code, and the
instructions given in this manual.
If the power source capacity is inadequate or the electric work is not
death.
NOTE
iar with the U.S. National Electric Code (NEC) who is equipped with the proper tools and test instruments.
Failure to carefully read and follow all instructions in this manual can result in equipment malfunction and property damage.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
SAFETY INSTRUCTIONS
Do not run the compressor with the service valves closed.
There is a risk of equipment damage.
Ensure the ductwork and its material follow local, state, and
federal codes for supplying / circulating air.
There is risk of product failure and / or damage.
the equipment.
Electrical shock can cause physical injury or death.
Properly size all circuit breakers or fuses.
Refer to local, state, and federal codes, and use power wires
strain relief.
Improperly securing wires will create undue stress on equipment power
cal injury or death.
-
-
5
Advertisement
Table of Contents
