Safety Symbols; General Safety Warnings - Ego Power+ LT0300E Operator's Manual

READ ALL INSTRUCTIONS!
READ OPERATOR'S MANUAL
WARNING:
To ensure safety and reliability, all
repairs and replacements should be performed by a
qualified service technician.

SAFETY SYMBOLS

The purpose of safety symbols is to attract your attention
to possible dangers. The safety symbols and the
explanations with them deserve your careful attention
and understanding. The symbol warnings do not, by
themselves, eliminate any danger. The instructions and
warnings they give are no substitutes for proper accident
prevention measures.
WARNING:
Be sure to read and understand all
safety instructions in this Operator's Manual, including all
safety alert symbols such as "DANGER," "WARNING," and
"CAUTION" before using this product. Failure to follow all
instructions listed below may result in electric shock, fire,
and/or serious personal injury.
Safety Alert
Read &
Understand
Operator's
Manual
Light Beam
Hot Surface
Class III
WEEE
Direct
Current
XX
4
56 VOLT LITHIUM-ION CORDLESS AREA LIGHT
Precautions that involve your
safety.
To reduce the risk of injury, user
must read and understand the
operator's manual before using
this product.
Do not stare into the light beam.
Risk of burns. Do not touch hot
surface.
Protection against electric shock.
Waste electrical products
should not be disposed of with
household waste. Take to an
authorized recycler.
Type or a characteristic of
current.
V Volt
min Minutes
A Amperes
mm Millimeters
lm Lumens
h Hours
K Kelvin
W Watt

GENERAL SAFETY WARNINGS

◾
Handle the light with care.
◾
Do not direct the light beam at persons or animals and
do not stare into the light beam yourself (not even from
a distance).
◾
Do not cover off the lamp head while operating the
light (the lamp head heats up during operation and can
cause burns when the heat accumulates).
BATTERIES
◾
The battery supplied is partially charged (to ensure full
capacity of the battery, completely charge the battery
in the battery charger before using your power tool for
the first time).
◾
Do not use battery when damaged; it should be
replaced immediately.
◾
Do not disassemble the battery.
◾
Do not expose tool/battery to rain. The light source
of this light is not replaceable; when the light source
reaches its end of life the whole light shall be replaced.
◾
Use only with the battery packs and chargers listed
below:
BATTERY PACK
BA1400, BA2800, BA4200,
BA1400T, BA2800T, BA4200T,
BA5600T, BA6720T
—
LT0300E
Voltage
Time
Current
Length of size
Luminous flux
Time
Measurement for temperature
Power
CHARGER
CH2100E, CH5500E,
CH7000E