Methods Of Using; Maintenance - Beko CT M 30 Instruction Manual

Please be sure to use the accessories provided by our company to install this electric
water heater. This electric water heater can not be hung on the support until it has been
confirmed to be firm and reliable. Otherwise, the electric water heater may drop off from
the wall, resulting in damage of the heater, even serious accidents of injury. When
determining the locations of the bolt holes, it shall be ensured that there is a clearance
not less than 0.2m on the right side of the electric heater, to convenient the maintenance
of the heater, if necessary.

4. METHODS OF USING

●
First, open any one of the outlet valves at the outlet of the water heater, then, open the inlet
valve. The water heater gets filled with water. When water flows out of the outlet pipe it implies
that the heater has been filled fully with water, and the outlet valve can be closed.
During normal operation, the inlet valve shall be always kept open.
● Insert the supply plug into the supply socket, the indicator will light up this time.
● The thermostat will automatically control the temperature. When the water temperature inside
the heater has reached the set temperature, it will switch off automatically, when the water
temperature falls below the set point the heater will be turned on automatically to restore the
heating.

5. MAINTENANCE

●
Check the power supply plug and socket frequently to make sure that they have good, reliable
contact and are well grounded without overheating phenomenon.
●
If the heater is not used for a long time, especially in the regions with low atmospheric tempera-
ture(lower than 0℃), the water inside the heater shall be drained away. This will prevent the
damage to the heater due to water freezing in the inner container, (Refer Cautions in this
manual for the method to drain away the water from the inner container).
●
In order to ensure that the water heater operates efficiently for a long time, it is recommended
to clean the inner container and the deposits on the electrical heating components periodically.
●
It is recommended to examine the magnesium anode protection materials every six months or
so. If all the material has been consumed, please replace with the new material.
!
Do cut off power supply before maintenance, to avoid danger like electric shock.
NOTE
NOTE
WARNING
7