Frigidaire FLCE752CAW Use & Care Manual page 33

Drying cycle controls
(Start, Pause, and Cancel)
START
Press DRYER
START|PAUSE button
once to begin the drying
cycle. The unit will emit
one beep before the
drum begins to rotate.
PAUSE
Press DRYER
START|PAUSE button
while the dryer is running
to pause the drying cycle.
Opening the door with a cycle running
will also pause the cycle. You will hear
two beeps. Allow the drum to come to
a complete stop before reaching inside.
Press the DRYER START|PAUSE button
while paused to restart the drying cycle.
CANCEL
Press the DRYER CANCEL button to
cancel the drying cycle. Wait for the
drum to come to a complete stop before
reaching inside.
Chime
Press and hold the DRY Temp button for
3 seconds to mute or unmute the chime
(on some models). Once muted, the
sound from the button press and the end
of cycle reminder will both be muted.
Dryer Setting Chart
These temperatures and water levels are available with the following cycles
Dry Temp (Drying Temperature)
High
Normal
Low
 = Available selections.
CONTROLS AND SETTINGS


 
= Factory presets.
Drying cycle indicator lights
The drying cycle
indicator lights
provide information
during the dry cycle.
T h e C l o s e D r ye r
Door advisory LED
will illuminate if the
dryer door is open.
Fully close the dryer
door before starting the dryer. The dryer will
not operate with the door open.

NOTE
The Clean Lint Filter LED will illuminate after
each drying cycle as a reminder to clean
the lint filter. The lint filter must be cleaned
after every load. This is NOT a warning of a
clogged exhaust duct or filter. Open door or
press CANCEL to turn off the LED.
The cycle status lights will illuminate as
each stage of the drying cycle is reached.
Stages include: Drying, Cooling, and Done.
 
 
 
= Non-modifiable presets.
33
  
  
  


