Related Manuals for NPC ReverseTap RD BF1
Summary of Contents for NPC ReverseTap RD BF1
- Page 1 ReverseTap In-counter Models Installation Guide ( KEGERATOR SYSTEM ) Incounter Models RD BF1 RD SF1 RD SF2 RD SF3 RD SF4 V2.0...
- Page 2 ReverseTap In-counter Models Installation Guide ( Kegerator ) * Required tools : Drill, Jig-saw, Driver, Hose cutter, Knife, Hose clamps, etc. 1. Decide a desired install position and cut out by the size shown below. - Please refer to ReverseTap website for hole dimension for each dispenser model. Model RD-BF1 RD-SF1...
- Page 3 ReverseTap In-counter Models Installation Guide ( Kegerator ) 3. Put ReverseTap on the desired surface. - Silicone is wrapped around the bottom borders of the dispenser for sealing purpose. Please be careful not to have it escape. *Silicone for sealing 4.
- Page 4 ReverseTap In-counter Models Installation Guide ( Kegerator ) 6. Connect the power and run a function test. - ① ReverseTap power turns ON as soon as power is connected. - ② To individually turn ON/OFF each unit, press START/STOP button in its keypad for a few seconds. - ③...
- Page 5 ReverseTap In-counter Models Installation Guide ( Kegerator ) 8. Connect beverage tubing to the flow sensor and the other end of beer line with a coupler. ① Flow sensor has fitting assembled already for 1/4 inch beer line. ( The inlet of flow sensor is 5/16 inch ) ②...
- Page 6 ReverseTap In-counter Models Installation Guide ( Kegerator ) 10. Install a coupler to a keg and set the CO2 gas pressure. ① Install a coupler to a keg and open the mid-valve, then set the gas pressure. * Recommended pressure for draft beer : 13 psi ~ 16 psi ②...
- Page 7 ( www.reversetap.com Trademarks • ReverseTap and ReverseTap logo are registered trademarks of NPC Co., Ltd. • Other names and marks are the property of their respective owners. Refunds / Exchange / Warranty Policy • Refunds or exchange may be offered within 15 days after purchase if the product cannot be used due to its defect.