Advertisement
ReverseTap In-counter Models Installation Guide ( Kegerator )
10. Install a coupler to a keg and set the CO2 gas pressure.
① Install a coupler to a keg and open the mid-valve, then set the gas pressure.
* Recommended pressure for draft beer : 13 psi ~ 16 psi
② Lock the gas pressure setting by fastening the lock nut.
③ Gas pressure tend to adjust itself after some drinks are dispensed, so some calibrations are required initially.
①
②
11. Settings (Preset Mode, Dispensing Amount, FOB Mode)
- Now all steps for installing the ReverseTap dispenser is complete.
- Kegs must be cooled down to 2℃~4℃ for proper use of ReverseTap.
- For initial use, initial settings must be done in steps as the following.
- When a cup is inserted for the first time, the following screen will show due to the FOB Mode (Function for blocking
foam popping )
- Press the 'STOP' button to deactivate FOB Mode, and proceed in order of
FOB Mode Activation
* FOB Mode is activated in
the first cup insertion.
* Enter the desired volume of
dispensing.
Cleaning
PRESET
( For detailed information, please refer to the S/W Manual or Quick User's Manual)
* Press the 'STOP' button to
deactivate the FOB Mode.
* Activate FOB Mode.
Dispensing
Amount
Cleaning → PRESET → Dispensing Amount →
* Remove foam from the tubing
by operating Cleaning Mode.
* Confirm the FOB Mode turned
ON in the Standby screen.
FOB
* Measure the flow rate by
operating PRESET Mode.
V2.0
Advertisement
