Related Manuals for NPC ReverseTap RD-B1
Summary of Contents for NPC ReverseTap RD-B1
- Page 1 ReverseTap Countertop Models Installation Guide ( KEGERATOR SYSTEM ) Countertop Models RD-B1 RD-BL2 RD S1 RD S2 / RD-SL2 RD S3 RD S4 V2.0...
- Page 2 ReverseTap Countertop Models Installation Guide ( Kegerator ) * Required tools : Drill, Jig-saw, Driver, Hose cutter, Knife, Hose clamps, etc. 1. Decide a desired install position and cut out by the size shown below. - Please refer to ReverseTap website for hole dimension for each dispenser model. RD-B1 RD-BL2 RD-S1...
- Page 3 ReverseTap Countertop Models Installation Guide ( Kegerator ) 3. Connect DC 24 V CONNECTOR CABLE with the main power cable of ReverseTap. - The end part of DC 24 V CONNECTOR CABLE is a waterproof connector. - DC plug of DC 24 V CONNECTOR CABLE is not waterproof, therefore keep it away from water and tape around the joint part.
- Page 4 ReverseTap Countertop Models Installation Guide ( Kegerator ) 5. Connect beverage tubing to the flow sensor and the other end of beer line with a coupler. ① Flow sensor has fitting assembled already for 1/4 inch beer line. ( The inlet of flow sensor is 5/16 inch ) ②...
- Page 5 ReverseTap Countertop Models Installation Guide ( Kegerator ) 7. Install a coupler to a keg and set the CO2 gas pressure. ① Install a coupler to a keg and open the mid-valve, then set the gas pressure. * Recommended pressure for draft beer : 13 psi ~ 16 psi ②...
- Page 6 ( www.reversetap.com Trademarks • ReverseTap and ReverseTap logo are registered trademarks of NPC Co., Ltd. • Other names and marks are the property of their respective owners. Refunds / Exchange / Warranty Policy • Refunds or exchange may be offered within 15 days after purchase if the product cannot be used due to its defect.