Advertisement
ReverseTap Countertop Models Installation Guide ( Kegerator )
* Required tools : Drill, Jig-saw, Driver, Hose cutter, Knife, Hose clamps, etc.
1. Decide a desired install position and cut out by the size shown below.
- Please refer to ReverseTap website for hole dimension for each dispenser model.
RD-B1
Vertical
130mm
Horizontal
140mm
- To be installed on flat and smooth surface. ( Insulating cold air is a critical issue in kegerator system )
- Be careful not to get hurt by the flying debris during the cut out process.
( Wearing safety goggles is recommended )
- Clear the debris after the cut out process.
*Wrench
*Tapeline
*Hose-cutter
*Hand-drill
2. Connect the Flow meter to the Solenoid valve set.
- ① Remove a lid from the solenoid valve set and insert the flow sensor.
( Please aware that the flow sensor is to be inserted as the indicated direction only )
- ② Insert the flow sensor connector to the Board assembled with solenoid valve set.
( The flow sensor connector and the Board socket are 3-pin )
- ③ Organize the cables.
( The flow sensor cable can be neatly wrapped around the solenoid valve set before inserted to the socket. )
* Please be careful not to have substances into the flow sensor.
①
②
RD-BL2
210mm
280mm
*Scissors
*Tape
*Screw driver
*Clamps
*Jig-saw
RD-S1
RD-S2 / RD-SL2
100 mm
210 mm
③
RD-S3
75 mm
350 mm
RD-S4
490mm
V2.0
Advertisement
