Case AXIAL-FLOW 7230 Tier 4a Operator's Manual page 19

Table of Contents

Advertisement

Coverage
The model year, class of diesel engine, and emission application determination for your engine are identified on the
Emission Control Information Label. This label is affixed to one of the following areas of the engine: the top of en-
gine's rocker arm cover, the right-hand side of the oil pan, and the right-hand side of the engine front gear cover.
The warranty period begins on the date the new equipment is sold to the first retail purchaser. The presence of the
emission control label is the indication that the engine conforms to the applicable standards. Any emission control
system parts which are proven defective during normal use will be repaired or replaced during the warranty period.
The engine owner has responsibility to perform all the required maintenance listed in the Owner's Manual. CASE IH
will not deny an emission warranty claim solely because no record of maintenance exists; however, a claim may be
denied if failure to perform maintenance resulted in the failure of a warranted part.
It is recommended that replacement parts used for maintenance or repairs be CASE IH Service Parts to maintain the
quality originally designed into your emission certified engine. The use of non- CASE IH parts does not invalidate the
warranty on other components unless the use of such parts causes damage to warranted parts.
The manufacturer is liable for damages to other engine components caused by the failure of any warranted emission
control system part. CASE IH is not responsible for failures resulting from improper repair or the use of parts that are
not genuine CASE IH or CASE IH approved parts.
Component coverage
New engines certified for sale and registered will have the following items covered by the emission warranty, depend-
ing on the emission level of the engine, if the items were first installed on the new engine as original equipment:
Fuel injection system
• Fuel injection pump
• Fuel injectors
• Fuel injection lines
Air induction system
• Intake manifold
• Turbocharger system (includes exhaust manifold)
• Charge air cooler
Positive Crankcase Ventilation (PCV) system (if
applicable)
• PCV valve
• Oil fill cap
Emissions warranty does not cover
• Repairs arising from storage deterioration, failure to maintain the equipment, negligence, alteration, improper use
of the equipment, collision or other accident, vandalism, or other casualty, or operation beyond rated capacity or
specification.
• Repairs arising from abuse or neglect, including but not limited to: operation without adequate coolant or lubricants,
adjustments to the fuel system outside equipment specifications, over-speeding, improper storage, starting, warm-
up, or shutdown practices, incorrect fuel or contaminated fuel, oil or other fluids.
• Normal maintenance services, such as engine tune-ups, engine fuel system cleaning, checks, adjustments, shim-
ming, etc.
• Items replaced due to customer demand.
• Labor charges performed by anyone except a dealer authorized by contract to repair the equipment, unless they
qualify under special provisions (i.e. outside labor).
• Any and all travel costs for items such as towing, service calls, or transporting a unit to and from the place where
the warranty service is performed.
1 - GENERAL INFORMATION
Exhaust after treatment Devices (if applicable)
• Diesel Oxidation Catalyst (DOC)
• Diesel Particulate Filter (DPF)
• Selective Catalytic Reduction (SCR)
• Diesel Exhaust Fluid (DEF) tank and dispensing sys-
tems
Exhaust Gas Recirculation Systems (EGR)
• EGR valve assembly
• EGR cooler
Cold Start Enrichment Systems
Electronic Control Units, Sensors, Solenoids, and Wiring
harnesses used in above systems
1-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Axial-flow 8230 tier 4aAxial-flow 9230 tier 4a

Table of Contents