Installation Instructions - Inalto IMC28BF User Manual

Installation Instructions

INSTALLATION SAFETY INSTRUCTIONS
DANGER: Electric Shock Hazard. Touching some of
•
the internal components can cause serious personal
injury or death. Do not disassemble this appliance.
WARNING: Electric Shock Hazard. Improper use
•
of the grounding can result in electric shock.
Do not plug into an outlet until appliance is properly
installed and grounded. This appliance must be
grounded. In the event of an electrical short circuit,
grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed
and grounded.
Consult a qualified electrician or serviceman if the
•
grounding instructions are not completely understood
or if doubt exists as to whether the appliance
is properly grounded. If it is necessary to use an
extension cord, use only a 3-wire
A short power-supply cord is provided to reduce
•
the risks resulting from becoming entangled in or
tripping over a longer cord.
If a long cord set or extension cord is used,
•
the marked electrical rating of the cord set or
extension cord should be at least as great as the
electrical rating of the appliance. The extension cord
must be a grounding-type 3-wire cord.
The long cord should be arranged so that it will not
•
drape over the counter top or tabletop where it can
be at risk of being pulled on by children or tripped
over unintentionally.
User Manual
INSTALLATION & CONNECTION
1 This appliance is only intended for domestic use.
2 This oven is intended for built-in use only. It is not
intended for counter-top use, or for freestanding
use inside a cupboard.
3 Please observe the special installation instructions.
4 The appliance can be installed in a 60cm wide wall-
mounted cupboard.
5 The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
6 The mains voltage must correspond to the voltage
specified on the rating plate.
7 The socket must be installed and connecting cable
must only be replaced by a qualified electrician. If the
plug is no longer to accessible following installation,
an all-pole disconnecting device must be present on
the installation side with a contact gap of at least
3mm minimum.
8 Adapters, multi-way strips and extension leads must
not be used. Overloading can result in a risk of fire.
Please note: the accessible surface may be hot
during operation.
06