Page 1
Flow series On-site ECA solution generator cleaning system The Centrego Flow Wash system Is designed to maintain the Centrego Flow series systems. Use of the Flow Wash system ensures the ECA cell and pipes are cleaned of any internal residue caused by hard water or for any other reason.
Page 2
4 - In line power switch hand or without full training from Centrego staff. No user service- 5 - in line Transformer able parts inside. 6 - Adapter for Flow device power cable...
Page 3
CENTREGO FLOW 40 CENTREGO FLOW 40 Remove Anolyte pipe from device Cell ushing system guide To remove the Anolyte pipe, nd the 'T' shaped The membrane cell is sensitive and requires regular checks and maintenance. The cell will connector as shown here with a yellow arrow.
Page 4
CENTREGO FLOW 40 CENTREGO FLOW 40 Open door and detach pipe Connect brine inlet on cell tube Locate a tube from the Flow wash system kit. Make sure one end of the tube can reach the inside of the Open the door of the Flow device Flow device and the other to the Flow wash system.
Page 5
CENTREGO FLOW 40 CENTREGO FLOW 40 Replace anolyte and catholyte tubes Rinse cell using water Remove the existing Anolyte and Catholyte tubes and then make sure that any excess moisture is With the Flow wash system still in place ll the Flow cleaned.