Panasonic KX-P1150 Operating Instructions Manual page 36

[roubleshootinč
117
Bunoouselgnoil ? SIUBUSILIEW
36
Most problems associated with the printer can be traced to improper setup, installation, or cabling.
The following table will assist the user in identifying and correcting some of the more common
problems. if you need additional help, contact the store from which the unit was purchased.
Move the TEE foward the lower |
i position (+) until ink doesn't
smear ( sa P. 10)
Printout is faint Head gap lever is not in proper | Set the lever to the proper ;
position position ( sw P. 10) i
Ink smears Head gap gue is not | in , the
proper position
Printhead moves but does not Ribbon is not installed correctly | Re-insert ribbon (15 P P. 12-13) |
Print | Head gap lever is not in proper ; Set the lever to the prôfar : :
| | position | position (se P. 10) !
Printer does not power up
Power is on but printer does not
print
! No AC power ; Check power cord ( es" P. 11 js
Printer is not ON LINE | Press ON LINE switch i
Interface cable is not properly ` Secure connection (Ew P. 11)
o
| (xx P. 14-17)
| Printhead has become | Allow the printhead some time to |
| |
overheated i cool down. The printer will ;
automatically resume printing — ;
` Carriage stops moving, all ` Path of printhead is blocked ; Clear the path, tum the power ,
. indicators start blinking | off, then back on to resume |
| printing
Set paper supply lower than
printer
Cut Sheet Feeder is Enable | Set Cut Sheet Feeder to Disable
when not using the Cut Sheet
Feeder { sv P. 21-28)
, Paper wrinkles when using
; tractor feed
Printer can't load single sheet in
Friction mode
, No reverse tension on paper
` Cut Sheet Feeder does not work Cut Sheet Feeder is Disable | Set Cut Sheet Feeder to Enable :
i (es P. 21-28)
Unexpected characters appear ^ Emulation is set incorrectly | Check printer driver of your .
- in printing : software package and set
: emulation accordingly
(us P. 18, 21-28) ;
j Set Download to Enable ;
Aia P. 21-28)
i Set Auto LF to OFF
: fem D 21.20
z XA cR Et ER
Set Auto LF to ON i
KX-P44 (buffer chip} is installed | Download is Disable
but cannot download
| Printout is double-spaced | Auto LF is ON
i Keeps printing on the same line | Computer is not sending a LF ,
: command y (se P.21-28)
` Wrong character set printed : Wrong character set selected Set the character set as required |
l
| (sw P.21-26) —
i
Table Troubleshooting