Panasonic KX-P1150 Operating Instructions Manual page 2

b A
IMPORTANT (FOR UNITED KINGDOM)
CLASS 1 FOR BS 7002
FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULL Y
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 5 amp
fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement fuse has
a rating of 5 amps and that it is approved by ASTA or BSI to BS 1362.
Check for the ASTA mark or the BSI mark on the body of the fuse.
if the plug contains a removable fuse cover you must ensure that it [s refitted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained.
A replacement fuse cover can be purchased from your local Panasonic Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR HOME. |
THEN THE FUSE SHOULD BE REMOVED AND THE PLUG CUT OFF AND DISPOSED OF S SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL SHOCK IF. THE CUT OFF PLUG IS INSERTED -
INTO ANY 13 AMP SOCKET. | |
If a new plug is to be fitted please observe the wiring code as shown below.
If in any doubt please consult a qualified electrician.
WARNING : THIS IS APPLIANCE MUST BE EARTHED.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Green-and-Yellow: Earth
Brown: Live
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows.
q AA A O a E MMC A IE IO FO
The wire which is coloured GREEN-AND-YEL LOW must be connected to the terminal in the plug which is `
marked with the letter E or by the Earth symbol @ , or coloured GREEN or GREEN-AND-YELLOW.
The wire which is coloured BLUE msut be connected to the terminal in the plug which is marked with the
letter N or coloured BLACK,
The wire which is coloured BROWN must be connected to the terminal in the plug which is marked with the
letter L or coloured RED.
How to replace the fuse Open the fuse compartment with a screwdriver and replace the fuse and fuse.
* This equipment is produced to BS800: 1988
All Rights Reserved. € COPYRIGHT 1993 KYUSHU MATSUSHITA ELECTRIC CO., LTD.
wis 4e
— e i — ¢ ¢
qe, Lr rr d