Caster Installation - Danby Premiere DDR30A2GP Owner's Use And Care Manual

CASTER INSTALLATION
Caster installation is recommended to avoid damage to floors.
1.Remove the casters from the bucket ofthe dehumidifier.
2. Position the dehumidifier onits side.
3. Locate the arrow on the bottom of the dehumidifier and insert
the caster according to the arrow direction.
4. Slide the caster in as far as it will go. The caster will snap
into place.
5. Repeat steps 1 to 4 for the other 3 casters.
OPERATING INSTRUCTIONS
Loe or
A O O
O
1) POWER Button: On / Off
2) FAN SPEED Button: High / Low
3) TIMER Button: When unit is operating, press
TIMER to set number of hours desired until unit will
shut off.When unit is in stand-by, press TIMER to set
number of hours desired until unit will turn on.
Setting timer from 1-24 hours. To cancel the timer,
proceed as above but set the "timer off" to zero (0)
hours.
4) °C/°F Button: Press the °C/°F button to toggle
between Celsius and Fahrenheit.
5) SET HUMIDITY/CURRENT HUMIDITY
DISPLAY: When machine is running, it displays the
| i
4
current humidity. Press UP or DOWN buttons to
select humidity setting. The humidity is adjusted in
increments of 5% b; cach press. Adjustable range is
within 30% RH to 90% RH. 10 seconds after
setting humidity, the display will change back to the
current humidity.
CURRENT TEMP/ TIMER SET DISPLAY:
en machine is running, it displays the current
temperature. Press the R button to set the
machine to shut off automatically after specified
amount of time. 10 seconds after displaying the timer,
the display will change back to current tempetauture.
7) DEFROST LIGHT: When temperature is low,
unit enters defrost mode and defrost light illuminates.
8) BUCKET FULL LIGHT: When water tank is
full, bucket full light illuminates.
€