Table of Contents
Advertisement
All Devices
Environment
Maximum Altitude
Pollution Degree
Indoor use only
Safety
Operate the GPIB controller only as described in the device user documentation.
Caution
documentation. Product misuse can result in a hazard. You can compromise the safety
protection built into the product if the product is damaged in any way. If the product
is damaged, return it to National Instruments for repair.
This product is designed to meet the requirements of the following electrical equipment safety
standards for measurement, control, and laboratory use:
•
IEC 61010-1, EN 61010-1
•
UL 61010-1, CSA C22.2 No. 61010-1
Caution
ratings on the equipment nameplate when connecting equipment to the supply circuit.
For UL and other safety certifications, refer to the product label or the
Note
Product Certifications and Declarations
Use a dry, low-velocity stream of air to clean the hardware. If needed, use a soft,
nonmetallic-bristle brush for cleaning around components.
Electromagnetic Compatibility
This product meets the requirements of the following EMC standards for electrical equipment
for measurement, control, and laboratory use:
•
EN 61326-1 (IEC 61326-1): Class A emissions; Basic immunity
•
EN 55011 (CISPR 11): Group 1, Class A emissions
•
EN 55022 (CISPR 22): Class A emissions
•
EN 55024 (CISPR 24): Immunity
•
AS/NZS CISPR 11: Group 1, Class A emissions
•
AS/NZS CISPR 22: Class A emissions
•
FCC 47 CFR Part 15B: Class A emissions
•
ICES-001: Class A emissions
32 | ni.com | GPIB Hardware Installation Guide and Specifications
Do not operate the GPIB controller in a manner not specified in the user
Overloading the circuits may damage supply wiring. Do not exceed the
2,000 m (at 25 °C ambient temperature)
2
section.
Advertisement
Table of Contents
