Recoil Rope; Ignition Switch - Polaris 550 Indy Sport 2024 Owner's Manual

Table of Contents

Advertisement

PRE-RIDE INSPECTIONS
HOOD AND SIDE PANEL FASTENERS
CAUTION
The hood and side panels of the snowmobile protect the operator from moving
parts. Never operate a snowmobile with the hood or side panels open or
removed. Always ensure that the hood and side panels are securely in place
before starting the engine.

RECOIL ROPE

Inspect the recoil rope and handle for excessive wear, and make sure the knot
securing the rope inside the handle is secure. If excessive wear is found, your
POLARIS dealer can provide a replacement.
START THE ENGINE AND CHECK
Before starting the engine, always refer to all safety warnings pertaining to
snowmobile operation. Never engage the starter when the engine is running.
Never start the engine without checking all vehicle components to be sure of
proper operation. See page 51.
ENGINE STOP SWITCH
Check the auxiliary shut-off switch for proper operation. Push the switch down to
stop the engine. Pull it up to allow restarting.

IGNITION SWITCH

Make sure the engine stops when the ignition switch is turned to OFF.
TETHER SWITCH (IF EQUIPPED)
If your snowmobile has a tether switch, remove the tether from the switch to
make sure the engine stops immediately.
LIGHTING
Check the headlight (high and low beam), taillight, and brake light. Replace
burned out lamps before operating.
MIRRORS (IF EQUIPPED)
Adjust the mirrors so they can be used to their full advantage.
OPERATING AREA
Before driving away, check your surroundings. Be aware of obstacles and make
sure bystanders are a safe distance from the snowmobile.
54

Advertisement

Table of Contents
loading

Table of Contents