Advertisement
DIAL CORD STRINGING /REPAIR
DIAL CORD
STRINGING
Tie the dial cord to the dial spring.
Set the dial pulley as illustrated.
Hook the dial spring on the boss A.
oh
ee
starting from its lower side.
2)
starting from its upper side.
8. Tie the end of the dial cord to the dial spring.
9. Remove the dial spring from the boss A.
_ Receive
a 90 MHz
signal, and
then
mount
the dial
pointer at the 90 MHz position of the dial calibrations.
POWER
TRANSISTOR
REPLACEMENT
Mica plate
Inslating bushing
{F29-0030-00)
Hexagon bolt
(NO9-0298-08)
Dress the dial cord in the direction
1 through 4.
Wind
the
dial
cord
two
turns
around
the dial
shaft
_ Dress the dial cord in the direction
5 to 6.
7. Wind
the dial cord two
turns
around
the dial pulley
Boss A
Dial spring
Advertisement
