V-Count Nano Quick Installation Manual

Nano Quick Installation Guide
What Is Included in the Box?
• V-Count Nano 3D Sensor
V-COUNT PEOPLE COUNTER
• Label for cables
+90 850 840 46 46
www.v-count.com
destek@v-count.com
• 7 cm bracket
• USB-C type 5V 2A EU adaptor
Use only USB-C type 5V 2A adaptors to avoid sensor damage. Use a UPS to prevent
electronic damage and data loss from power cuts.
If you choose to use PoE, PoE Splitter is SOLD separately. Use only relevant PoE
switches and splitters that comply with the IEEE 802.3af standard as Nano's
maximum power requirement is 10W.
*You can set up your device using either Wi-Fi or a cable connection.
Alternative -1: Requirements for Installation with Wi-Fi
1. A mobile phone to connect and configure the sensor.
2. The username and password of the modem to connect to
the device.
3. The serial number located on the back of the device
4. Mobile app and its password - You can obtain the password
from our support.
5. Scan the QR code suitable for your operating system to
download the mobile app.
6. You can set up your device through the "Setup Sensor" menu,
under the "Profile" section on the mobile app.
*Please configure the Wi-Fi settings through our application,
not the local interface.
Alternative -2: Requirements for Installation with CABLE
1. A laptop to connect and configure the sensor.
2. A PoE Splitter, in case a PoE switch is being used.
Please note that PoE is not included in the box; you may need to purchase it separately.
For information about PoE installation, please scan the QR code down below.
3. A laser meter to measure the ceiling height.
4. An Ethernet cable to connect the unit to the switch.
Ensure sufficient cable length from installation to switch point, not exceeding 90 meters
for CAT5/CAT6 cables.
5. An Ethernet crimp tool and a cable tester to check cable health.
6. A ladder to install the unit.
Scan the QR Code for Configuration
and Calibration
If you experience a problem with calibration and configuration,
please scan the QR code, fill out the form with the serial ID from
the back of the unit (starts with D0 A0 11 3X XX XX), and request
configuration and calibration after completing the installation.
Installation Steps
Step- 1: Identify the Installation Point
• Confirm the installation location before installing the unit.
• V-Count sensors are usually placed near entrance doors.
• Choose sensor locations carefully to avoid obstructions like inward-opening doors
that can affect data quality.
• Consider different installation scenarios to select the most suitable for your location.
BOOSTBI APP
Detailed
Installation Guide