Video - Axis M42 Series User Manual

AXIS M4218-LV Dome Camera
The web interface
Upgrade firmware: Upgrade the firmware on your device. Takes you to the Maintenance page where you can do a firmware
upgrade.
Connected clients
Shows the number of connections and connected clients.
View details: View and update the list of the connected clients. The list shows IP address, protocol, port, and PID/Process
of each client.

Video

Click to play the live video stream.
Click to freeze the live video stream.
Click to take a snapshot of the live video stream. The file is saved in the 'Downloads' folder on your computer. The image
file name is [snapshot_YYYY_MM_DD_HH_MM_SS.jpg]. The size of the snapshot depends on the compression that the specific
web-browser engine where the snapshot is received applies, therefore, the snapshot size may vary from the actual compression
setting that is configured in the device.
Click to show I/O output ports. Use the switch to open or close the circuit of a port, for example, to test external
devices.
Click to manually turn on or turn off the IR illumination.
Click to manually turn on or turn off the white light.
Click to access onscreen controls:
• Predefined controls: Turn on to use the available onscreen controls.
• Custom controls: Click
Starts the washer. When the sequence starts, the camera moves to the configured position to receive the wash
spray. When the whole wash sequence is completed, the camera returns to its previous position. This icon is only visible when the
washer is connected and configured.
Starts the wiper.
Click and select a preset position to go to that preset position in the live view. Or, click Setup to go to the preset
position page.
Adds or removes a focus recall area. When you add a focus recall area, the camera saves the focus settings at
that specific pan/tilt range. When you have set a focus recall area and the camera enters that area in the live view, the camera
recalls the previously saved focus. It's enough to cover half of the area for the camera to recall the focus.
Click to select a guard tour, then click Start to play the guard tour. Or, click Setup to go to the guard tours page.
Add custom control to add an onscreen control.
16