Table of Contents
Advertisement
Clamp
Clamp bolt
Cover
Coin battery
(CR2032)
O-rin
Déclaration
Cet équipement respecte les limites
r ayo n n e m ent s IC R S S - 102 dé fi ni e s pour un
environnement non contrôlé. Cet équipement doit être
installé et mis en marche à une distance minimale de
0.2 in (0.5 cm) qui sépare
corps.
Installing the coin battery (CR2032)
The Display Unit needs to be removed and installed for
changing the coin battery.
Remove the clamp by loosening the four bolts and re-
move the display from the handle.
When installing the Display Unit, tighten the four clamp
bolts from the back side of the clamp.
WARNING
Tighten the clamp bolts to 2 N·m. Otherwise, during
riding, vibration could cause the clamp bolts to come
loose with the risk that the Display Unit may fall off. A
loose display could distract the rider or interfere with
control and cause an accident.
Coin battery (CR2032)
Check if the rated coin battery is installed in the rear of the
Display Unit.
If a coin battery is not installed, or if there is not sufficient
battery power remaining, install a new coin battery.
After installing a new coin battery, turn the power on once
g
and then off so that the Display Unit can recognize the
coin battery.
In case of setting the language, see
41
à la radiation:
rayonnant de votre
Advertisement
Table of Contents
