Yamaha PASC4 Owner's Manual page 25

Display
Button
Display angle
adjust bolt
Display fixing bolt
Mounting and removing the display
To mount the display, slide the display toward the rear
side of the bicycle, and then insert it into the display hold-
er. To remove the display, press the button while sliding
the display towards the front of the bicycle out of the dis-
Display
play holder.
holder
TIP
Adjust the display angle by loosening the display angle
adjust bolt. The angle depends on each rider. After ad-
justing the display angle, tighten the display angle ad-
just bolt to 0.5 N·m.
Make sure the display is turned off before mounting or
removing it.
Fixing the display
The display can be secured to prevent easy removal.
Make sure that the display is properly set in the display
holder firmly.
Then, install the display fixing bolt (M3 thread, 12 mm
long) from underneath. If the display fixing bolt cannot be
installed nor removed due to interference of the handle-
bar, loosen the clamp bolts, and then remove the display
holder from the handlebar.
WARNING
Clamp bolt
Tighten the clamp bolts to 1.2 N·m. Otherwise, during
riding, vibration could cause the clamp bolts to come
loose with the risk that the Display Unit may fall off. A
loose display could distract the rider or interfere with
control and cause an accident.
Handle
TIP
The structure that secures the display is not designed for
anti-theft.
21