Other Information
For playback operations of SiriusXM~ Radio
sources and other settings information, refer to the
INSTRUCTION MANUAL on the following website:
<
https://www.kenwood.com/ cs/
eel>
•
The availabi lity of each source vary depending on
the model.
■
Note for specifications
Bluetooth Frequency Range:
2.402 GHz -
2.480 GHz
Bluetooth RF Output Power (E.I.R.P.):
+4 dBm (MAX), Power Class 2
Speaker Impedance:
40-80
Operating Voltage:
12 V DC car battery
~
ENGLISH
Installation and Connection
This section is for the professional installer.
For safety's sake, leave wiring and mounting to
professionals. Consult the car audio dealer.
A
WARNINGS
•
DO NOT connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
•
DO NOT cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
•
Always connect the ignition wire (red) and the
battery wire (yellow) to the power source running
through the fuse box.
A
CAUTIONS
•
Install this unit in the console of yo~r car.
•
Do not touch the metal parts of this unit during and
shortly after the use of the unit. Metal parts such as
the heat sink and enclosure become hot.
•
When parking at a low ceiling area, turn off the unit
to store the antenna. As when the unit is installed in
the car with the function of auto antenna; the radio
antenna extends automatically when you turn on
the unit with the antenna control wire (ANT. CONT)
connected (page 31
).
Before installation
■
Precautions on installation and connection
•
Mounting and wiring this product requires skil ls and
experience. For best safety, leave the mounting
and
wiring work to professionals.
•
Mount the unit so that the mounting angle is 30° or
less.
•
Make sure to ground the unit to a negative 12 V DC
power supply.
•
Do not install the unit in a location exposed to direct
sunlight or excessive heat or humidity. Also
avoid
places with too much dust or
t
he possibility
of
water
splashing.
•
Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
•
After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
•
Do not press hard on the panel surface when
installing the unit to the car. Otherwise scratches,
damage, or failure may result.
•
If the power is not turned on ("Miswiring DC Offset
Error", "Warning DC Offset Error" is displayed),
the speaker wire may have a short circuit or have
touched the chassis of the
car
and the protection
function may have been activated. In this case, t he
speaker wire should be checked.
•
Keep all cables away from heat dissipating metal
parts.