Opening The Filter - TMC Power Filter 125 Instructions Manual

1. Carefully close the tap on the
water inlet hosetail so that it is
in the fully closed position.
4. Carefully disconnect the water inlet and outlet hosetails from the
pump housing.
PLEASE NOTE: There may be some water remaining in the inlet
and outlet hosetails so, to avoid spillages, special care should
be taken when disconnecting these parts from the pump
housing.

OPENING THE FILTER

2. Carefully close the tap on the
water outlet hosetail so that it
is in the fully closed position.
17
POWER
OFF
3. Immediately after closing the
two taps, turn off the power
supply to the filter.
CAUTION: After closing the
taps the power supply must
be switched off IMMEDIATELY
as failure to do so will
damage the pump and cause
operating problems.
5. Gently open the safety locks.
CAUTION: To avoid spillages,
when removing the pump
housing from the filter
housing ensure that you
carefully lift it vertically and
allow any water remaining
in the pump housing to drain
back into the filter housing.