Disassembly Instructions; Removal Of Mechanical Parts And P.c. Boards - Sanyo DP32671 Service Manual

1. REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
CAUTION
Be careful not to remove the LVDS cable forcibly, because
the LVDS cable may be damaged.
1-1: STAND ASS'Y (Refer to Fig. 1-1)
1. Remove the 2 screws (1).
2. Remove the Stand Ass'y in the direction of arrow.
Stand Ass'y
1-2: BACK CABI ASS'Y (Refer to Fig. 1-2)
1. Remove the screw (1).
2. Remove the 15 screws (2).
3. Remove the Back Cabi Ass'y in the direction of arrow.
(2)
(2)
(2)
(2)
(1)
(2)
(2)

DISASSEMBLY INSTRUCTIONS

(1)
(1)
Fig. 1-1
(2)
(2)
(2)
(2)
(2)
(2)
(2)
(2)
(2)
Fig. 1-2
1-3: DVD MT PCB / LOADER UNIT (Refer to Fig. 1-3)
1. Remove the 4 screws (1).
2. Remove the Shield Deck in the direction of arrow (A).
3. Remove the screw (1).
4. Remove the DVD MT PCB in the direction of arrow (B).
5. Disconnect the following connectors:
6. (CP2301, CP2302, CP2303, CP3002 and CP4201).
7. Remove the Loader Unit in the direction of arrow (C).
(1)
(A)
DVD MT PCB
(B)
Loader Unit
(C)
Front Cabi Ass'y
NOTE
1. Before your operation, please read "PREPARATION
OF SERVICING".
2. Use the Lead Free solder.
3. Manual soldering conditions
• Soldering temperature: 350 ± 5
• Soldering time: Within 4 seconds
• Soldering combination: Sn-3.0Ag-0.5Cu
4. When Soldering/Removing of solder, use the drawing
equipment over the Pick Up Unit to keep the Flux
smoke away from it.
5. When installing the DVD Deck, remove all the soldering
on the short circuit position after the connection of Pick Up
PCB and DVD MT PCB connector.
B1-1 B1-1
(1)
(1)
(1)
Shield Deck
(2)
Short circuit using
a soldering iron.
Pick Up PCB
o
C
Fig. 1-3