For Liquid Detergent; Use The Measuring Aid For Liquid Detergent; Adding Detergent And Care Product; Starting The Programme - Bosch WAX32M40SG User Manual And Installation Instructions

13.6 Use the measuring aid

for liquid detergent

To add liquid detergent, you can use
a measuring aid in the detergent
drawer.
Pull out the detergent drawer.
1.
Slide the measuring aid forwards.
2.
Fold the measuring aid down and
3.
click it into place.
Push in the detergent drawer.
4.
13.7 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→ Page 29.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 18
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.8 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 30
Press Start / Reload
▶
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: -0-.
13.9 Soaking laundry
Note: No additional detergent is re-
quired. The washing solution is then
used for washing.
Start the programme.
1.
To pause the programme, after ap-
2.
prox. 10 minutes, press Start / Re-
.
load
To resume the programme, after
3.
the desired soaking time, press
Start / Reload
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
Press Start / Reload
1.
The appliance pauses.
Note: If you want to add laundry,
follow the instructions on the dis-
play.
→ "Display", Page 22
Open the door.
2.
operation en
.
.
.
31