Basic Operation; Switching On The Appliance; Setting A Programme; Adjusting The Programme Settings - Bosch WAX32M40SG User Manual And Installation Instructions

en operation
operation
13 Basic operation
operation
13.1 Switching on the appli-
ance
Requirement: The appliance has
been correctly installed and connec-
ted.
→ "Installation and connection",
Page 12
Press .
▶
The switch-on process takes a few
seconds.
Note: The lighting for the drum goes
out automatically.
13.2 Setting a programme
Turn the programme selector and
1.
set the required programme.
→ "Programmes", Page 25
If required, adjust the programme
2.
settings.
→ "Adjusting the programme set-
tings", Page 30
13.3 Adjusting the pro-
gramme settings
Requirement: A programme has
been set.
→ "Setting a programme", Page 30
Adjust the programme settings.
▶
→ "Buttons", Page 23
Note: The programme settings are
not saved permanently for the pro-
gramme.
13.4 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 25
30
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 29
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Inserting the measuring
aid for liquid detergent
If you order the measuring aid as an
accessory, you must use the measur-
ing aid.
Pull out the detergent drawer.
1.
Press down on the insert and re-
2.
move the detergent drawer.
Insert the measuring aid.
3.
Insert the detergent drawer.
4.