Table of Contents
Advertisement
5.
Remove the 2 bolts (1/2 x 1-3/4 inch) and 2
locknuts (1/2 inch) securing the motor assembly
and remove the motor assembly
Figure 11
1. Bolt—1/2 x 1-3/4 inch (2)
2. Locknut—1/2 inch (2)
6.
On the opposite side of the broom, remove the 4
bolts (1/2 x 1-1/4 inch), 4 spring washers, and 4
locknuts (1/2 inch) securing the bearing mount
plate
(Figure
12). Remove the bearing mount
plate with the bearing still attached.
Note:
The core should now be free from the
brush head.
Figure 12
1. Bearing mount plate
2. Locknut—1/2 inch (4)
7.
Lift open the hood and remove the core.
8.
Remove the 6 bolts, 6 nuts, and the retaining
plate
(Figure
13).
(Figure
11).
g271159
3. Motor
g271158
3. Spring washer (4)
4. Bolt—1/2 x 1-1/4 inch (4)
1. Bolt—3/8 x 1 inch (6)
2. Retaining plate
9.
Slide the brushes off the broom.
Installing the Brushes
1.
Inspect the broom core for damage or excessive
wear. Replace it if it is damaged.
2.
Stand the broom core on end. Starting with
a polypropylene brush, install new brushes,
ensuring the prongs straddle the rods of the core
(Figure
14). Alternate between polypropylene
and wire brushes, with each consecutive brush
180° apart.
Note:
The last brush installed should be a
polypropylene brush.
1. Prongs
2. Rod
12
Figure 13
3. Nut—3/8 inch (6)
Figure 14
3. Polypropylene brush
4. Wire brush
g271160
g271173
Advertisement
Table of Contents
