Ssl CLZMF Installation And Operation Instruction Manual

CLZMF — INSTALL INFORMATION AND OPERATION INSTRUCTIONS
CAUTION: BEFORE CONNECTING THE LUMINAIRE TO A POWER SUPPLY, MAKE SURE THE POWER IS SWITCHED OFF.

GENERAL:

1. Before starting the installation, make sure all electricity has
been turned off and electrical breaker has been locked out
and tagged out.
2. To ensure the success of the installation, be sure to read
these instructions and review the diagrams thoroughly
before beginning.
3. All electrical connections must be in accordance with local
codes, ordinances, or the National Electrical Code.
NOTE: The important safeguards and instructions appearing in
this manual are not meant to cover all possible conditions and
situations that may occur.
Installation:
Recommended: Due to the weight of the luminaire it is
recommended to use two installers for safe handling.
1. Identify all parts are present for assembly and use a sturdy
surface to complete assembly. Fig 1
2. Prepare end bolts for assembly by placing the Split
Washer on the bolt. Fig 2
3. Re-Insert the end-bolts onto the housing and hand-tighten.
4. Using the arrows located on side of luminaire, adjust beam
target. Fig 3
5. Once desired angle is reached, Tighten to 90 IN-LBS with
a 5 mm hex
WARNING: Failure to tighten luminaire to an adequate torque
value will result 3G vibration Failure.
©SOLID STATE LUMINAIRES.
DETAILED ILLUSTRATION
Fig 1
BIT TYPE: 5 MM
5 MM
TIGHTEN TO 90 IN-LBS
END BOLT
SPLIT-WASHER
Fig 3
USE ARROWS ON
SIDE OF LUMINIAIRE
TO ADJUST ANGLE
BEFORE TIGHTENING
Fig 2
LOCTITE 271
SPLIT-WASHER
0.75 inch
1.10 inches
APPLY LOCTITE HERE
BETWEEN MEASUREMENTS
t 800.900.1730
3609 Swenson Ave.
St. Charles, IL 60174
Loctite 271
CLZMF
TG-TD-092623