Satrap GS179B Instructions For Installation And Use Manual page 12

YOUR APPLIANCE
. A B
CAPTION
A Electronic thermometer*
B Mechanical thermometer*
C Switch*
0 Thermometer knob
E Drawersand/orflaps
F Freezing calendar
G Base trim
H Adjustable feet
L Fast freezing compartments
M Compressor
N Condenser
* Available with some models only
Drawing is purely illustrative
REVERSIBIÜTY ÖFTRE
DOOR
The opening of the door is usually to the left (hinges on the right), if instead you wish to invert it,
you may proceed äs illustrated in the following pages. If your model does not have base trim, begin
reading from next page.
Should your appllance have different types of hinges, you may tfaen refer to the illustrations that
correspond to your type.
Base trim removal
1. Remove the base trim Y by unscrewing the screws (fig. 5). If you have the type X (fig. 6) use
hands to find the little tongue located halfway along the underside of the base trim. To release
them from the pins gently pull downwards. Rotate the base trim upwards to unhook it.
2. For both X and Y types extract the little tongue C (fig. 7/8) from its position on the left and
reinsert into the position the right.
Put the modified base trim aside and proceed according to the following instructions.