Advertisement
3. TAPE DECK RECORDING
AND
PLAYBACK
@® PLAYBACK
@ Depress the PROGRAM
SELECTOR
switch to
the TAPE 1 (or TAPE 2) position.
PROGRAM SELECTOR —————-_,
a MM
AUX
TUNER
PHONO =~
a, MC
=
@ Operate the tape deck in the playback mode.
@ Now
set
the
desired
volume
level
with
the
ATTENUATOR
contol.
,
@ |f the tape deck is-fitted with an output level
control, adjust this so that your ATTENUATOR
setting gives you approximately the same volume
as it would when listening to the TUNER section.
@ RECORDING
@ Depress the RECORD SELECTOR switch to the
program source you wish to'record.
(RECORD
SELECTOR
a
291
w2
AUX
TUNER
PHONO:
OFF
SRS
BSS SSS
,
Zn
ERK
ER =m EH
@ Operate the tape deck in the recording mode.
@ Play the source to be recorded.
@ If you
depress
the
PROGRAM
SELECTOR
switch to the same program source, you will be
able to hear the program 'you are recording. You
can,
of course,
listen
to any
other
program
source while the recording is in progress.
© If your tape deck is of the three-head kind (with
separate record, playback and erase heads), you
'will be able to monitor the recording while it is
being made. Depress the PROGRAM SELECTOR
to TAPE 1 (or TAPE 2 — whichever you are using).
© Adjust the recording
level with the input level
controls on the tape deck.
NOTE:
The ATTENUATOR,
tone controls, fil-
ters, etc., have no effect on the record-
ing.
®
DUPLICATING
Duplicating
is simply playing back a tape on one
tape deck and recording it on another.
@ Depress the RECORD
SELECTOR
switch to the
172 (or2—>1).
ooo
RECORD SELECTOR, $$
Wz
AUX
'UNER
PHONO
OFF
< i
—|—|——|—
ZH
-
EH HE EH
E
@ Operate one tape deck, connected to the PLAY 1
(or PLAY
2) inputs, in the playback mode, and
the other, connected to the REC 2 (or REC 1)
outputs, in the recording mode.
@ Other
instructions are exactly the same as for
recording and playback (as detailed).
4, PLAYING FROM OTHER SOURCES
@ Depress the PROGRAM
SELECTOR
switch to
the AUX position.
ss
RECORD SELECTOR
a
Wace? eat
291
2
TUNER
PHONO
OF
'
eS
eS
RB
BH HB S
@ Operate the unit (8-track tape cartridge player,
etc.).
;
@ Now
set the desired
volume
level with
the
ATTENUATOR
control,
5, LISTENING WITH HEADPHONES
@ Plug the headphones into the PHONES output.
@ Now
set the desired
volume
level with
the
ATTENUATOR
control.
@ The speakers will not be automatically muted :if
you do not want to use them, switch them off
with the SPEAKERS (A, B) switches.
@ Low impedance
(8 ~ 16 ohms) headphones are
best. Higher impedance headphones may require
rather
higher
setting
of the
ATTENUATOR
control.
Be sure to turn the volume down again
before switching back to your speakers.
Advertisement
