Advertisement
INSTALLATION INSTRUCTIONS
We strongly recommend having your amplifier installed by your
dealer or a professional installer. If you have any reservations about
installing electronic components in you vehicle or do not have the
proper equipment to do so, please allow your dealer to perform the
installation. If you feel you can do the installation yourself, read the
following instruction very carefully. If you encounter any problems,
please contact your dealer.
MOUNTING THE AMP
Position the amplifier in a area with adequate ventilation such as
in the trunk or under the seat. This is necessary to dissipate the
heat radiated by the amplifier's heat sink. It is not recommended to
mount the amplifier upside-down as this may cause the amp to go
into thermal protection prematurely. The amp should be mounted
vertically or horizontally. Be sure to mount the amplifier securely.
POWER ACOUSTIK CAN NOT BE HELD RESPONSIBLE FOR
DAMAGE OR INJURY DUE TO INCORRECT MOUNTING OF
THE AMPLIFIER.
AMPLIFIER CONNECTIONS
INPUT CONNECTIONS
Connect the right and left RCA outputs of the head unit, pre-amp
or crossover to the corresponding inputs of the amplifier. In the
bridge mode only one input needs to be used, as the bridging
switch parallels the inputs.
Be sure to use high quality cables to
insure a good signal path. Remember to always route signal cables
away from power and high tension lines in the vehicle.
Advertisement
