Table of Contents
Advertisement
REMOTE CONTROL
CAUTION
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage. Handle the
control with care and avoid getting the control wet.
IMPORTANT: The remote control can operate the unit from a distance
of up to 26 ft. (8 m) as long as there are no obstructions. When the timer
function is used, the remote control should be kept in the vicinity of the
fan coil (within 26 ft. / 8 m).
The remote control can perform the following basic functions:
• Turn the system ON and OFF
• Select the operating mode
• Adjust room air temperature set point and fan speed
• Adjust right-left airflow direction
Refer to "WIRELESS REMOTE CONTROL" on page 4 for a
detailed description of all the capabilities of the remote control.
Battery Installation
Two AAA 1.5v alkaline batteries (included) are required for remote
control operation.
To install or replace batteries:
1. Slide the back cover off the control to open the battery
compartment.
2. Insert the batteries. Follow the polarity markings inside the battery
compartment.
3. Slide back the battery compartment cover.
NOTES:
1. When replacing batteries, do not use old batteries or a different type
battery. This may cause the remote control to malfunction.
2. If the remote is not going to be used for several weeks, remove the
batteries. Otherwise, battery leakage may damage the remote
control.
3. The average battery life under normal use is about 6 months.
4. Replace the batteries when there is no audible beep from the indoor
unit or if the Transmission Indicator fails to light.
When batteries are removed, the remote control erases all presets (e.g.,
Follow Me). The presets must be restored after the insertion of new
batteries.
REMOTE CONTROL OPERATION -
QUICK START
Remote Control Operation − Quick Start
NOTE: When transmitting a command from the remote control
to the unit, be sure to point the control toward the right side of the
unit. The unit confirms receipt of a command by sounding an
audible beep.
1. Turn the unit on by pushing ON/OFF.
6
2. Select the desired mode by pushing MODE.
3. Select the temperature set point by pointing the control toward the
4. Press FAN to select the desired fan speed.
NOTE:
speed will be automatically set and cannot be adjusted.
Set the airflow direction. When the unit is turned on, the Up-Down air-
flow louvers default to the cooling or heating position. The user can adjust
the horizontal Up-Down airflow louver position by pushing DIRECT or
have continuous louver movement by pressing SWING.
BASIC REMOTE CONTROL OPERATION
Before operation, ensure the unit is plugged in and power is available.
COOL Mode
1. Press MODE to select the COOL mode.
2. Set your desired temperature using TEMP
3. Press FAN to select the fan speed in a range of AU'100%,
4. Press ON/OFF to start the unit.
Setting Temperature
The operating temperature range for units is 60-86°F (16-30°C)/(68-
82 °F (20-28°C) (depends on model). You can increase or decrease the
set temperature in 1°F(0.5°C) increments.
Specifications subject to change without notice.
NOTE: If there is a preference for °C rather than °F (default),
press and hold the TEMP
or TEMP
approximately 3 seconds.
AUTO
COOL
DRY
Fig. 4 — Modes
unit and pressing the increase/decrease temperature set point
buttons until the desired temperature appears on screen.
If the unit is operating in DRY or AUTO mode, the fan
1
4
3
Boost
Fig. 5 — COOL Mode
together for
FAN
HEAT
2
or TEMP
OM-DHMVHA-01
Advertisement
Table of Contents
