A Note About Safety; General - CAC / BDP DHMVHA Owner's Manual

A NOTE ABOUT SAFETY

Any time you see this symbol
be aware of the potential for personal injury. There are 3 levels of
precaution:
1. DANGER identifies the most serious hazards which will result in
severe personal injury or death.
2. WARNING signifies hazards that could result in personal injury or
death.
3. CAUTION is used to identify unsafe practices which could result
in minor personal injury or product and property damage.
NOTE is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
WARNING
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury, death
or property damage.
Improper installation, adjustment, alteration, service, maintenance,
or use can cause explosion, fire, electrical shock, or other
conditions which may cause personal injury or property damage.
Consult a qualified installer, service agency, or your distributor or
branch for information or assistance. The qualified installer or
service agency must use factory-authorized kits or accessories
when modifying this product.
Read and follow all instructions and warnings, including labels
shipped with or attached to unit before operating your new air
conditioner.
2
in manuals, instructions and on the unit,
Specifications subject to change without notice.

GENERAL

The unit provides quiet, maximum comfort. In addition to cooling and/or
heating, the Ductless unit matched with an outdoor condensing unit filters
and dehumidifies the air in the room to provide maximum comfort.
IMPORTANT: The unit should be installed by authorized personnel
only; using approved tubing and accessories. If technical assistance,
service or repair is needed, contact the installer.
The unit can be set up and operated from the remote controller
(provided). If the remote controller is misplaced, the system can be
operated from the "Auto" setting on the unit.
Operating Modes:
The outdoor unit has five operating modes:
• FAN ONLY
• AUTO
• HEATING
• COOLING
• DEHUMIDIFICATION (DRY)
FAN ONLY
In the FAN ONLY mode, the system filters and circulates the room air
without changing the room air temperature.
AUTO
In the AUTO mode, the system automatically cools or heats the room
according to the user-selected set point.
NOTE: AUTO mode is recommended for use on single zone
applications only. Using AUTO CHANGEOVER on multi-zone
applications could set an indoor unit to STANDBY mode, indicated
with two dashes (--) on the display. STANDBY mode turns off the
indoor unit until all the indoor units are in the same mode; either
COOLING or HEATING.
HEATING
In the HEATING mode, the system heats and filters the room air.
HEATING is the system's priority mode. Simultaneous HEATING
and COOLING is not allowed.
COOLING
In the COOLING mode, the system cools, dries and filters the room
air.
DEHUMIDIFICATION (DRY)
In the DEHUMIDIFICATION mode, the system dries, filters and
slightly cools the room air temperature. This mode prioritizes air
dehumidification however it does not take the place of a dehumidifier.
Wireless Remote Controller
The wireless remote control transmits commands to set up and operate
the system. The control has a window display panel that displays the
current system status. The control can be secured to a surface when
used with the mounting bracket provided.
24V Interface (Optional)
Allows the control of the unit with a third party thermostat (field
supplied).
OM-DHMVHA-01