Assembly - Delta 36-T30 Instruction Manual

UNPACKING AND CLEANING
Carefully unpack the machine and all loose items from the shipping container(s). Remove the rust-preventative oil from unpainted
surfaces using a soft cloth moistened with mineral spirits, paint thinner or denatured alcohol.
Do not use highly volatile solvents such as gasoline, naphtha, acetone or lacquer thinner for cleaning your
machine. After cleaning, cover the unpainted surfaces with a good quality household paste wax.
To reduce the risk of injury, turn unit off and disconnect it from power source before installing/removing
accessories, adjusting, or making repairs. An accidental start-up can cause injury.
TOOLS REQUIRED
5/32" Hex Wrench (supplied)
3/16" Hex Wrench (supplied)
Rail Alignment Gauge (supplied)
Standard Screwdriver (not supplied)
Phillips Screwdriver (not supplied)
Adjustable Wrench (not supplied)
1/4" Drill and Drill Bit (not supplied)
INSTALL FRONT GUIDE RAIL
1.
With the left edge of the Front Guide Rail (1) near
the edge of the Left Extension Wing, align the Two
Holes in the table with the Two Holes in the Front
Guide Rail, as indicated at location "A" in Figure 3.
2.
Secure the Front Guide Rail to the table with
two 5/16" Countersunk Screws (c), 5/16"
External Tooth Lock Washers (a), and 5/16"
Hex Flange Nuts (b). Finger tighten only.
3.
Ensure the Front Guide Rail is parallel to the
cast iron Table Top by using the rail Alignment
Gauge (g) to check the distance from the top
surface of the Front Guide Rail to the top of
the table at both sides of the Saw Table.
4.
Attach the remaining Countersunk Screws (c) through
the holes in the Front Guide Rail and Extension
Wings using External Tooth Lock Washers (a) and
Hex Flange Nuts (b) as needed. Ensure the Extension
Wings are level with the cast iron Table Top.
5.
Tighten all hardware securing the Front
Guide Rail to the Table Top.
NOTE: The Front Guide Rail and Rear Guide Rail of the 36-T50
an Extension Table. If you plan to install an Extension Table to your Table Saw, install it before attaching the Guide Tube. Based on
your saw model some holes in the Front Guide Rail and Rear Guide Rail may not be used.

ASSEMBLY

1
have additional holes in the Extension End that are used to attach
T3
6
g
A
FIGURE 3