ASROCK iEP-7020E Series User Manual page 4

• The equipment shows obvious signs of breakage.
13. Never attempt to repair the device, which should only be serviced by qualified
technical personnel using suitable tools.
14. Any unverified component may cause unexpected damage. To ensure correct
installation, always use the components (e.g., screws) provided in the accessory box.
15. This equipment is not suitable for use in locations where children are likely to be
present.
16. The equipment should only be installed in a restricted access area.
17. Restricted Access Location : It is recommended that the device be installed only in a
server room or computer room where access is:
• Restricted to qualified service personnel or users familiar with restrictions
applied to the location, reasons therefor, and any precautions required.
• Only afforded by the use of a tool or lock and key, or other means of security, and
controlled by the authority responsible for the location.
• Be sure to turn off the power and then disconnect the power cords from your
system before performing any installation or servicing. A sudden surge of power
could damage sensitive electronic components.
• All interior servicing is to be performed by qualified skilled personnel only, which
requires the use of a tool for open the metal enclosure.
DIN Rail/Wall Mount: M3x5mm Screws
VESA Mount: M4x6mm Screws
18. This model is intended to be supplied by an UL-certified power supply (Adapter: (1)
FSP/FSP120-ABAN3, (2) FSP/FSP330-AAAN3) suitable for use at TMA 40 °C (104
°F) min., and the output is rated 19 Vdc 3.42A min., ES1. (For FSP120-ABAN3) / 24
Vdc 13.75A min., ES1 (For FSP330-AAAN). If you need further assistance, contact
ASRock Industrial for additional information.
19. The terminal block is suitable for V+& V- for 14~28AWG. The torque value is 0.19Nm.
Use copper conductors only. Kindly note that this must be installed by a skilled
person.
(for securing the mounting bracket(s) to the chassis)
(for securing the VESA bracket to the monitor)