Kenwood TM-201A Instruction Manual page 5

4
© MHz/M3 (1 MHz up) key
@ M/M4 (memory input)
key
© AL/MB5 (alert) key
ALi
E
@ A/B (VFO A/B selection,
scan stop) key
A/B
i
@ MIC connector (8 pin)
@ COM (common channel) key
For users other than Europe and England.
COM
=
[mat]
TONE switch (For British version)
TONE
It
For memory input, refer to page 15.
During memory recall operation, depressing this key recalls memory CH4.
When depressed, the ALERT indicator lights to show alert operation is in pro-
gress.
During memory recall operation, depressing this key recalls memory CH5.
Memory channel 5 is used for odd split operation as for memory channel 4.
The frequencies (transmit and receive) stored in CH5 designate frequency
range limits for programmable scan operation.
For more details, refer to page 15.
As shown in the table, this key provides three types of operation.
A/B key functions
Each time the key is depressed, VFO A and B are selected
alternately.
@ up
@ DWN
© 8C{+ 8V)
(10 mA Load)
@®NC
@® STBY(PTT)
@ Mic
GND
Note: Do not apply voitage to
pins @, @, and ®@.
The pin © should not be
shorted
nor applied any
voltage.
FRONT VIEW
When this switch is pressed, the repeater control tone burst signal (1 ,750 Hz)
is emitted for about 0.5 seconds at the beginning of each transmission.
TONE
=