Kenwood TM-201A Instruction Manual page 11

e Antenna Installation
Front fender Trunk lid system
Installation for mobile operation.
Be sure to use a duplex mobile antenna.
Coax. cable routing
© Power supply
@ Ignition noise
antenna instruction.
Antenna installation
Antenna bracket
Remove the paint to in-
sure grounding to the
car body.
Pass through the rear
Y
window.
is)
Pass through the door fit-
ting. The cable can be in-
serted easily if the door
cushion is soft. Note that
rain water may enter
along the cable.
Lift the trim plate and
install the cable.
excessive voltage drop.
Insert through the firewalt
ee one TM-201A
p PILI, We
Battery - f eDUMMI Utne
Rubber grommet
|
To battery
Connect directly to the battery terminals.
resistors).
For this purpose, the TRIO-KENWOOD
PG-3A is available.
1i