Rear Wheel - Yamaha PW50 2006 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
1
2
3
1. Retainer
4
3. Insert the wheel axle from the right
side.
4. Install the washer and axle nut,
5
and then tighten the axle nut to the
specified torque.
6
Tightening torque:
Axle nut:
7
40 Nm (4.0 m·kgf, 28.9 ft·lbf)
8 5. Connect the brake cable at the
wheel hub, and then install the
brake cable free play adjusting nut.
9
6. Adjust the brake lever free play.
(See page 6-14.)
7. Take the motorcycle off the center-
stand so that the front wheel is on
the ground.
8. Push down hard on the handlebar
several times to check for proper
fork operation.
6-20

Rear wheel

To remove the rear wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motorcy-
cle so that there is no danger of
it falling over.
1. Place the motorcycle on the cen-
terstand.
2. Remove the seat. (See page 3-6.)
WARNING
Always let the exhaust system cool
prior to touching exhaust compo-
nents.
3. Remove the muffler bolt and
washers.
EAU25080
EAU41081
EWA10820
EWA14580