Advertisement

Artist-1024
8.4
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Artist-1024 and is the answer not in the manual?

Questions and answers

Summary of Contents for Riedel Artist-1024

  • Page 1 Artist-1024 User Manual...
  • Page 2 © December 2022 Riedel Communications GmbH & Co. KG. ALL RIGHTS RESERVED. UNDER THE COPYRIGHT LAWS, THIS MANUAL MAY NOT BE COPIED, IN WHOLE OR IN PART, WITHOUT THE WRITTEN CONSENT OF RIEDEL. EVERY EFFORT HAS BEEN MADE TO ENSURE THAT THE INFORMATION IN THIS MANUAL IS ACCURATE. RIEDEL IS NOT RESPONSIBLE FOR PRINTING OR...
  • Page 3: Table Of Contents

    Artist-1024 User Manual V8.4 Installing License ......................28 Content Appendix Preface Glossary ......................... 29 Information ........................4 Maintenance Recommendations ................30 Safety Instructions ......................5 Service ..........................30 Change History ....................... 7 Index..31 Firmware Version ......................7 About Artist-1024 ......................8 Artist-1024 - Node Frame (MFR-1024) ......................
  • Page 4: Preface

    Riedel Communications GmbH & Co. KG shall not be liable for any errors, inaccuracies or for incidental or Indicates a potentially hazardous situation which, if not avoided, may result in minor or consequential damages in connection with the furnishing, performance or use of this manual, the software moderate injury.
  • Page 5: Safety Instructions

    · Never bypass a ground contact. · All service has to be undertaken only by qualified Riedel service personnel. · The mains plugs is used as a disconnect device. It is imperative that access to the mains plugs and ·...
  • Page 6 Artist-1024 User Manual V8.4 Laser Safety Artist-1024 devices / cards can be equipped with optical fiber modules (FOM) for the data transmission over a fiber. Observe the following guidelines and warnings: · Because invisible radiation might be emitted from the aperture of SFPs when no fiber cable is connected, avoid exposure to radiation and do not stare into open apertures.
  • Page 7: Change History

    No changes have been made to the content since the last version 8.3, so the content of this document This manual refers to firmware version 8.4 of the Artist-1024 system and describes the current version of remains valid for Artist 8.4.
  • Page 8: About Artist-1024

    With Artist-1024 you get more than just full IP standards compliance and massive port As its name suggests, the Artist-1024 node boasts 1024 non-blocking ports in just a 2RU frame size. This densities. What you get is the full power of the sophisticated Artist intercom ecosystem, a versatile and unparalleled port density significantly reduces rack space requirements and creates powerful efficiencies future-proof solution that continues to evolve with industry developments and standards.
  • Page 9: Artist-1024 - Node

    Artist-1024 User Manual V8.4 Artist-1024 - Node front view The Artist-1024 node incorporates the display and is shipped with two redundant power supplies and one Position Card type ü fan module with two high quality fans. Furthermore two front and one rear filter are part of the delivery Bay 1 –...
  • Page 10: Info Display

    If the Artist-1024 is connected to mains voltage, the default view is displayed: 2.1.1 Info Display The display shows system and license information of the Artist-1024 node. As the display uses e-paper · Basic configuration information is shown to equip technology, this information is visible in the on and off state.
  • Page 11: Operation

    Artist-1024 User Manual V8.4 2.1.3 Operation SIC (Status Info) In the Artist-1024 can be navigated through the display as follows: Transport Type Turning the rotary encoder Select the next / previous slot Number of ports configured/assigned in Director A horizontal line is displayed above/below the currently selected slot position.
  • Page 12: Led Wedge (Wdg-1024)

    Artist-1024 User Manual V8.4 LED Wedge (WDG-1024) Front Filter (FRF-1024) The WDG-1024 card guides the air flow through the rack and thus ensures sufficient cooling of the The top and bottom front filters protect the inside of the rack from dust and dirt.
  • Page 13: Power Supply (Psu-1024)

    Power Supply (PSU-1024) Fan Unit (FAN-1024) There are two power supplies in an Artist-1024 node: On the one hand, the energy is provided equally by The Artist 1024 node has a fan unit with 2 high quality and quiet fans.
  • Page 14: Technical Drawing

    With this mounting option the cabling can be easily and quickly carried out on the front of the frame and can also be changed again. figure 13: Artist-1024 – technical drawing (front view) If the mounting brackets are mounted rotated by 180°, the front of the unit faces into the rack and allows cabling from the rear of the rack.
  • Page 15: Technical Specification (Frame)

    Artist-1024 User Manual V8.4 Technical Specification (Frame) Number of ports per frame 16 ... 1024 Number of ports per card 8 ... 128 Licensing Virtual Artist Matrix (VAM) license which includes a defined number of ports (16 to 1024) that can be freely distributed across the node’s subscriber cards.
  • Page 16: Artist-1024 - Cards

    In version 8.0, the configuration and IP address is stored on the respective card. Downstream (link output) If a UIC-128 in an Artist-1024 node has to be replaced, the configuration and IP address must be · The downstream port is connected to the upstream port of the next Artist frame in manually stored on the card to be replaced.
  • Page 17: Status Leds

    Artist-1024 User Manual V8.4 3.1.2 Status LEDs 3.1.3 Port Types The table shows in which card configuration which port types are available in Director. Card configuration Port selection Port/Panel type AES67-SIC MADI-SIC ü 1200 series RSP-1232HL – ü RSP-1216HL –...
  • Page 18: Features In Detail

    Artist-1024 User Manual V8.4 Features in Detail Replacing Front-Filter The two air filters are located in the fan grilles on the front. NIC Redundancy Follow the steps below to replace the air filters: The NICs in Bay 3 and Bay 8 are now fully synchronized and redundant.
  • Page 19: Replacing Rear-Filter

    Artist-1024 User Manual V8.4 Replacing Rear-Filter Reversing the Airflow The rear filter is located at the rear of the fan unit. If necessary, the direction of the air flow can be reversed by turning the fan block. Follow these steps to replace the rear filter: Carry out the following steps: Ø...
  • Page 20 Artist-1024 User Manual V8.4 Ø Ø Carefully pull the fan block upwards from the Carefully slide the fan unit into the subrack. circuit board. Ø Fasten the fan unit with the 4 knurled screws. Ø Turn the fan block 180° and carefully insert it back onto the circuit board.
  • Page 21: Connections

    Artist-1024 User Manual V8.4 Connections Recommended SFPs Connector Connector Cable Type Cable length Max. Opt. Type SFP type UIC type Article Data rate Connector Mode distance budget CAT5 RJ 45 FTP (4x2 AWG 24) Up to 100 m SFP-MADI SIC (MADI)
  • Page 22: Licensing

    Artist-1024 introduces a new customer-friendly, flexible licensing scheme with frame-level licensing instead The Artist-1024 frames need licenses for operation. If the Artist-1024 is not already licensed, the license file of connectivity-type licensing. Each node starts with a Virtual Artist Matrix (VAM) license which includes a is provided by your local distributor.
  • Page 23: Flexible License

    Only then log in to the Riedel License Manager web portal to download and manage licenses. https://license.riedel.net/ Flexera User Portal Riedel clients have access to the Flexera portal, that is entirely for use with user account/data management. Users are able to ... ·...
  • Page 24: Forgotten Password

    Artist-1024 User Manual V8.4 5.4.2 Forgotten Password 5.4.3 User Profile & Security Ø Ø Click on "Forgot Password?". After login click on "User Name / Profile". Ø Change basic information and click on "Save". Ø Click on "Security". Ø Enter email (username).
  • Page 25: Riedel License Manager

    Riedel License Manager Ø Click on the left side in the "Devices" area on the download button of the Artist-1024 frame whose Riedel customers have access to the Riedel License Manager where licenses can be managed. license you want to download.
  • Page 26: Extending License

    Ø Assign new licenses to the Artist-1024 frame. There are three different ways to do this: Click on the plus button of the Artist-1024 frame whose license you want to extend on the left side in the "Devices" area. Click on the plus button of the license you want to assign to an Artist-1024 frame in the "Entitlements"...
  • Page 27: Moving License

    Moving License Ø Upload this license response file to the Riedel License Manager. There are two different ways to do this: F-VAE licenses can be moved between Artist-1024 frames. Click on the upload button of the Artist-1024 frame whose license you have removed and select the Ø...
  • Page 28: Content 5.6 Installing License

    Format an USB pen drive in the FAT32 or NTFS file format. Ø Create the following folder structure: "\\Riedel\Artist-1024". Ø Copy the previously downloaded license file into that folder. The folder can contain multiple license files. Each Artist-1024 frame will pick its corresponding license file. Ø Power up the Artist-1024. Ø...
  • Page 29: Appendix

    (connected via fiber). Network Interface Card – Interface to connect multiple Artist frames. Node A single Artist-1024 with interface cards to which the individual subscribers, audio connections, GPIs and fibre optic connections can be connected. PNIC Primary NIC (Bay 3, independent if active or standby) Port Analog or digital interface to the node to connect i.e.
  • Page 30: Maintenance Recommendations

    Set “Autosave” in the Director software. Warning Your primary point of contact for any service issues is your local dealer. In addition, Riedel Customer Service in Wuppertal, Germany is also available to assist you. · Because invisible radiation might be emitted from...
  • Page 31: Index

    Artist-1024 User Manual V8.4 Keyword Index Disposal 4, 6 LED Wedge (WDG-1024) RSP-2318 (BASIC, PLUS, PRO) Downloading License (Riedel License Manager) License Model - S - - 1 - DSP-2312 (BASIC, PLUS) Licensing Safety Instructions 1200 series Licensing (First Steps)
  • Page 32 Riedel Communications GmbH & Co. KG Uellendahler Str. 353 42109 Wuppertal Germany www.riedel.net...

Table of Contents

Save PDF