JVC KD-A11 Service Manual page 6

KD-A11A/B/C/E/J/U |
Front plate assembly ..........
Remove 5 screws (3 screws (3) on upper side and 2
screws (4) on bottom side.) fastening the front plate
assembly.
(Top View) (Bottom View)
Screws ® This screw is fastened
with same as earth wire.
Front panel assembly
1. Remove a screw(S) fastening the button escutcheon
ass'y (left side)
2. Open the cassette holder, and remove a screw fastening
the arm ass'y for oiled-gear damper.
3. Remove 4 screws (6) fastening the front panel. (left and
right ..... 2 screws on each)
4. Remove a washer and a nut @) fastening the REC
LEVEL control VR shaft.
5. Remove a screw (8) fastening the lever switch on main
amp P.W. Board ass'y.
(Mechanical assembly is removed with the same as front
panel.)
Screws @)
Washer and nut Screw Screw ()
MECHANICAL ASSEMBLY
1. Remove the counter belt from counter. 2) Remove 4 screws (Q) fastening the front plate.
2. Remove 4 screws (Q) fastening the front panel. (When assembling the mechanical control plate, it need a
new parts = the mechanical control plate cannot use
If you remove the mechanical assembly with not removed
the front panel, do the following method.
1) Remove the mecha control plate.
again.)
Screws @)
Screws (9)