Advertisement
PS SP PEER, GOTT TTS
DIAL
CORD
ARRANGEMENT
Fig. 1.
Set the varicon to minimum
frequency and string the cord by following the number sequence order
as shown in Fig. 1.
ALIGNMENT
INSTRUCTIONS
This cassette radio has been aligned at the factory and normally will not require further adjustment.
As a result, it is not recommended
that any attempt is made to modificate any circuit.
If any paris are
replaced or if anyone tampers with the adjustment, realignment may be necessary.
Test equipment required
1. AM/FM signal generator
2. IF sweep generator (10.7 MHz) for FM
3. 1F sweep generator (455 kHz or 465 kHz) for AM
5. Standard loop antenna for AM
6. VTVM
7. Oscilloscope
8. Frequency counter
9. Audio frequency oscillator
10. Test tapes
a) MTT-144 (10 kHz)
b) MTT-122B
(1 kHz)
c) MTT-501
(Blank tape)
Advertisement
