Kenwood TS-50S Instruction Manual page 49

8 OPERATION USING ACCESSORIES
i se
3 > When tuning is finished, AT TUNE and ON AIR if 10 KHz steps are selected via Menu B, No. 61 then
go off, and the previous modulation mode is additional tuning flexibility in the Broadcast Band is
restored. available by using Menu A, No. 17 to reduce the step
If tuning is not finished within 30 seconds, an size further. Refer to Menu Set-up on page 46.
alarm beep sounds. Press the AT TUNE button to
end the tuning operation.
Note: /f an alarm sounds, the antenna system may have PTT BUTTON
failed. Check the antenna system first.
Hold down the PTT button to transmit. Press this
4 Confirm that the antenna system functions button once while scanning to stop scan. Disable the
normally, and press the AT TUNE button again. PTT button by changing Menu B, No. 65. Refer to
Menu Set-up on page 47.
Note:
Sy ST Til i is
UP AN UWN BULIUNS
Press the UP or DWN button in the VFO made to
raise or lower the operating frequency. Press either
button in the Memory Channel mode to select any
channel. In the Menu Set-up mode, use the buttons to
switch through all selections of the displayed menu
item. Hold down either button to continuously change
the frequency, memory channel or menu item
selection.
Se srernie entn nan a eens Se een aes \ y wey
automatically within the new group. \ / fe /
\ Fi \ /
The transceiver frequency step can be changed from \ / \ /
the microphone. Refer to Menu Set-up (Menu A, No. Ld ae!
16 and No. 17). 10 kHz is the default. It is also = oo oS
a - . ht. =
= ne "