Kenwood TS-50S Instruction Manual page 27

3 COMMUNICATION
RECEPTION
1
27
After the "HELLO" message, the frequency and
the other indicators will appear on the display.
Select the receive frequency using the UP and
DOWN buttons and the tuning control.
The frequency may be changed in 1 MHz steps
using the UP or DOWN button (1 MHz indicator
on).
Use the SSB/CW or FM/AM button to select the
desired mode.
For digital operation, SSB or FM is used
depending on the operating band, and LSB is most
common for packet and RTTY. Refer to the table
on page 28. For AMTOR, USB is normally used.
Use Menu A, No. 4 with the SSB/CW button if it is
necessary to select the opposite sideband. Refer
to Menu Set-up on page 46.
Select FAST AGC for these digital modes using
Menu A, No. 2. Refer to Menu Set-up on page 46.
Set the AF control at 10 o'clock, or as suggested
by your TNC Instruction Manual.
Adjust the transceiver tuning control using the
TNC tuning indicator. Refer to your TNC
Instruction Manual for tuning indicator details.
Communication
terminal
Computer
system
MIC connector and TNC signal cable
Viewed from
the front
No.
Signal line name
/TXD
"Standby (PTT)
_ (Microphone, DOWN)
(Microphone, UP)
(Microphone, 8V)
RXD
(Microphone, GND)
2
3
4
5.
6
7
8
GND