Kenwood TS-50S Instruction Manual page 19

2 CONTROLS AND CONNECTORS
A a ED
DISPLAY
MENU AIP ATT NB A VFO 8 SPLIT FAST SLOW F.LOCK 1MHz
@ M.CH 7 — 7 a | —_ RIT: By 8 OEE. 6. 66 do Set
anleo Gauls amle » emle Li. kHz! dt. ay. kHz ac
9) 20 o
ae em TT TL use hale M.SCR_PRG_SCAN;——®
2 4 6 8 10 LS8/ USB CWNIFM AM} TONE
@ MENU @) IMHz
Appears when entering the MENU Set-up mode. Appears when the MHz function is on. Also appears in
the Memory Channe! made when selecting from only
programmed channels, or the Memory Scroll mode
@ AIP when choosing empty memory channels.
Appears when the Advanced Intercept Point function
is selected with the AIP/ATT button. @ M.CH
Appears after switching to the Memory CHannel mode
@ ATT using the M/V button.
Appears when the ATTenuator is selected with the
: rr ——
{
1
(ot deepen ecmmnppencpyremmmcmmmmmmmends
Ppears when t ie Noise Bilanker Is on. @ Dot
Appears when memory channels are locked-out. Refer
&) AVFOB to Memory Channel Lock-out, on page 38.
Either A VFO or VFO B appears, depending on which
VFO is selected with the A/B button. ® Digital frequency display
te Displays the operating frequency.
©) SPLIT
Appears when the SPLIT frequency function is on. @ RIT
Appears when Receiver Incremental Tuning is on.
@ FAST/SLOW
Either FAST or SLOW appears, depending on which +e .
AGC speed is selected. (No indicator appears in the @ Digital RIT display
FM mode.} Displays the amount of frequency shift with the RIT
on, the scan speed value during scan, or the one and
ten Hertz frequency digits when using the MC-47.
F.LOCK
Appears when the Frequency LOCK function is on.
19