Page 1
TC-AC 420/50/10 V Originalbetriebsanleitung Manual de instrucciones original Kompressor Compresor Original operating instructions Alkuperäiskäyttöohje Compressor Kompressori Instructions d’origine Оригинальное руководство по Compresseur эксплуатации Компрессор Istruzioni per l’uso originali Compressore Originalna navodila za uporabo Kompresor Original betjeningsvejledning Kompressor Eredeti használati utasítás...
13. Quick-lock coupling (unregulated com- Danger! When using the equipment, a few safety pre- pressed air) cautions must be observed to avoid injuries and 14. Oil sealing plug damage. Please read the complete operating 15. Oil level window instructions and safety regulations with due care. 16.
3. Proper use 5. Before starting the equipment The compressor is designed for generating Before you connect the equipment to the mains compressed air for tools operated by compressed supply make sure that the data on the rating plate air. are identical to the mains data.
6.2 Fitting the supporting feet (4) Fit the supplied supporting feet (4) as shown in Fig. 6. 8. Cleaning, maintenance and ordering of spare parts 6.3 Replacing the oil sealing plug (14) Remove the transportation cover from the oil ller Danger! opening and screw the supplied oil sealing plug Pull the power plug before doing any...
condensation water in an environmentally 8.7 Storage compatible manner at the appropriate collec- Warning! tion point. Pull the mains plug out of the socket and ventilate the appliance and all connected pneumatic tools. 8.3 Safety valve (10) Switch off the compressor and make sure that it is The safety valve has been set for the highest per- secured in such a way that it cannot be started up mitted pressure of the pressure vessel.
10. Possible causes of failure Problem Cause Solution The compressor 1. No supply voltage. 1. Check the supply voltage, the pow- does not start. er plug and the socket-outlet. 2. Insuffi cient supply voltage. 2. Make sure that the extension cable is not too long.
Page 10
For EU countries only Never place any electric power tools in your household refuse. To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and its implementation in national laws, old electric power tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g.
Service information We have competent service partners in all countries named on the guarantee certi cate whose contact details can also be found on the guarantee certi cate. These partners will help you with all service re- quests such as repairs, spare and wearing part orders or the purchase of consumables. Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required for use as consumables.
Page 12
Warranty certi cate Dear Customer, All of our products undergo strict quality checks to ensure that they reach you in perfect condition. In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card.
Need help?
Do you have a question about the TC-AC 420/50/10 V and is the answer not in the manual?
Questions and answers