GeoSlam ZEB CRADLE Unboxing And Setup Instructions

Zeb go accessory

Table of Contents

Download this manual

Unbox and Assemble with the ZEB Go

Table of Contents

Need help?

Do you have a question about the ZEB CRADLE and is the answer not in the manual?

Page 1 Unbox and Assemble with the ZEB Go...
Page 2 Table of Contents 1. Unboxing 2. Assembly List of Figures 1. Cradle for ZEB Go with attached mount, fixing screws and screw accessory kit 2. Scanner mounting plate on the base of the cradle 3. Handle detached from the scanner head 4.
Page 3 1. Unboxing When a cradle compatible with the ZEB Go system is received, it will be pre-assembled with the datalogger fixing screws attached on the side of the cradle and the scanner head mounting plate attached to the base. A screw accessory kit will also be included which contains all of the screws needed to attached the ZEB Go system to the cradle.
Page 4 2. Assembly Step 1. Remove the scanner mounting plate from the base of the cradle. This can be done by unscrewing the two fixing screws on the side of the plate. Figure 2. Scanner mounting plate on the base of the cradle Step 2.
Page 5 Figure 4. Mounting plate fixed to the back of the scanner head Step 4. Re-attach the mounting plate (with the scanner head attached) to the base of the cradle using the fixing screws. Figure 5. ZEB Go scanner head attached to the cradle Step 5.
Page 6 Step 6. Re-attach the battery to the datalogger and connect the power cable. Figure 7. ZEB Go datalogger and battery attached to the cradle Step 7. Connect one end of the ZEB Go main cable into the datalogger and the other end into the side of the scanner.