1.2 Product description 1.3 Instructions for charging You should fully charge the FINDER before using it for the first time. Please USB-C port proceed as follows. LED signals ON/OFF button Connect the supplied charging cable to the USB-C port of the FINDER.
1.4 Activation Plug the USB wall plug adapter In order to use your POWER Finder 4G, you will need to previously activate into a power socket. it online. Enter the following link and follow the instructions: start.finder-portal.com Wait for the end of the char- ging process.
1.5 Start-up 1.6 Use When the activation is successfully, you can start the POWER Finder 4G. The on/off switch is located under the protective flap. Switch on: To turn the FINDER on, slide the switch to the right. The LEDs then flash for 5 seconds.
1.8 Standby mode and location update 1.9 Meaning of the LED lights By default, our devices send their position to the FINDER portal every 30 seconds, so you can always see the current location there. Orange LED - Network status What is the standby mode? Signal Meaning...
1.10 Alerts 1.11 Technical data Weight Movement/Shock alert 280 g Receive a notification as soon as your GPS tracker is either Dimensions 118 x 67 x 37 mm moved or shaken. Battery time standby: ca. 90 days / in operation*: ca. 40 days Battery type Geofence alert 3.7 V / 10.000 mAh Li-ion...
1.12 Safety Instructions Safety Signal words WARNING! RISK OF ELECTRIC SHOCK! The following signal words are used in these operating instructions: A faulty electrical installation or a mains voltage that is too high can lead to an electric shock. • Before use, make sure that the mains voltage of the socket corresponds NOTE! This is a warning about possible damage to property.
Page 10
• PAJ GPS shall not be liable for any damage or loss (whether in contract or tort, NOTE! including negligence) arising from your failure to comply with these warnings and instructions.
Page 11
Declaration of conformity WARNING! RISK OF DAMAGE! Hereby, PAJ UG (haftungsbeschränkt) declares that the tracker, POWER Finder 4G, is in conformity with the Directive 2014/53/EU. The complete text of the EU Decla- Below you will find information and instructions on how to clean the GPS tracker: ration of Conformity can be found at the following Internet address: paj-gps.de/konformitaetserklaerung/...
1.13 Disposal of used batteries 1.14 Disposal of electric devices The following note is addressed to those who use batteries or products with The Electrical and Electronic Equipment Act (ElektroG) contains a large number of requirements for the handling of electrical and electronic equipment. The most im- products with built-in batteries and who will not resell them in the form in which portant ones are summarised here: they were supplied to them (end users).
Page 13
PAJ UG (haftungsbeschränkt) Hohe Straße 61 PAJ UG (haftungsbeschränkt) 51570 Windeck Hohe Straße 61, 51570 Windeck Germany Germany Mail: support@paj-gps.com Phone: +49 2292 39 499 59 Web: paj-gps.com The PAJ GPS Team wishes you to enjoy your POWER Finder 4G!