Subscribe to Our Youtube Channel
Related Manuals for BabyLove Baby Capsule
Summary of Contents for BabyLove Baby Capsule
- Page 1 Baby Capsule CLICKTIGHT compatible IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT...
-
Page 2: Table Of Contents
Contents QUICK SETUP GUIDE • REARWARD FACING SEATBELT HOW TO INSTALL IN AN AIRCRAFT MEET YOUR CHILD SEAT IMPORTANT INFORMATION AND WARNINGS SHOULDER HEIGHT MARKERS OUTGROWN YOUR CHILD SEAT BRITAX STROLLERS CHILD SEAT SUITABILITY GUIDE CARE AND MAINTENANCE • CLEAN HARNESS BUCKLE CHILD SEAT FEATURES - REARWARD FACING •... - Page 3 Hey! before you install me... Don’t forget to note your Lift serial number found on the seat to complete your REMOVE warranty registration. SLACK Close ClickTight Press and hold Recline Check base Adjustment button is secure PINCH POINT UNDER HANDLE Adjust foot Lock capsule Lengthen...
- Page 4 Harness Straps Not Below Green Zone Pull to Store strap tighten SLACK Remove slack You have now successfully completed the seat belt installation . Check angle of child seat is still correct. Press Pull Press Under Capsule Remove straps from yoke Choose correct slot...
- Page 5 Place top Attach tether clip tether loop around capsule TWISTS TWISTS Replace through straps to guide yoke Crotch Strap Options Lap Strap Options Store strap Pull to AVERAGE tighten NEWBORN INFANT LAP LOW BIRTH Remove SLACK WEIGHT LAP HIGH slack Lock capsule Install child &...
-
Page 6: Meet Your Child Seat
Meet Your Child Seat Meet Your Child Seat The baby capsule and base is installed so that the infant is facing Suitable for low birth weight and premature infants without rearwards. This provides best position in a crash for infants. -
Page 7: Important Information And Warnings
Important Information And Warnings Important Information And Warnings IMPORTANT : • TO BE USED WITH A LAP-SASH OR LAP-ONLY SEATBELT IN THE • Use the restraint exactly as shown in the instructions. BACK OF MOST CARS WITH FORWARD FACING SEATS •... -
Page 8: Shoulder Height Markers
Shoulder Height Markers Shoulder Height Markers A Shoulder Height Marker is featured on this baby capsule. This is an indicator for when your infant has outgrown the seat and it IMPORTANT: Follow this advice. should be superseded. Height Marker If your child’s shoulders are above the height marker, they have outgrown the seat. -
Page 9: Outgrown Your Child Seat
2 to 3 years of age. • Dedicated Forward Facing Seat with in-built harness: Suitable for children who have outgrown their Baby Capsule (from approximately 6 months old), up to approximately 4 years of age, or 8 years of age depending on the restraint. -
Page 10: Child Seat Features - Rearward Facing
Child Seat Features - Rearward Facing Child Seat Features - Rearward Facing Carry Handle Rebound Bar Recline Adjustment Button Rearward Shoulder height ClickTight markers Facing Button Handle Belt Path (Blue) Release Buckle tongue Button holders Level Indicator Seat cover ClickTight Shoulder Pads Handle Infant Insert... -
Page 11: General Information
Do not use on any vehicle seat which faces sideways or rearwards. Long or short The Baby Capsule may just touch the front seat, but must not in Vehicle Seat such a way that the installation angle is affected. Protector... -
Page 12: Adjusting The Base Angle
Setup - Adjusting the Base Angle Setup - Adjusting the Base Angle The Level Indicator shows when your child seat is installed at the Figure .A. correct angle for your vehicle. It gives you confidence the child seat is positioned correctly whenever you travel. Lift Press and hold Recline Adjustment button... - Page 13 Setup - Installing Into Your Vehicle Setup - Installing Into Your Vehicle Lift Thread the seat belt under the ClickTight and through the blue REARWARD FACING BELT PATH guide. NOTE: Ensure the seatbelt is tucked under the ClickTight completely. Do NOT thread seatbelt through ClickTight handle Pull up and hold the...
-
Page 14: Installing Into Your Vehicle
Setup - Top Tether Setup - Installing Into Your Vehicle Lock capsule Press top tether adjuster Lengthen strap on base button. Pull Lengthen top tether strap fully, ensure all Ensure unnecessary twists are secure Push removed. Place the top tether over the vehicle seatback, and if needed, remove Check vehicle seatbelt is... - Page 15 Setup - Top Tether Setup - Top Tether CAUTION: CHILDREN CAN BE INJURED OR Pull to tighten Ensure slack is removed RESTRAINTS AND TOP TETHER STRAP DAMAGED from the top tether straps by pulling top tether BY UNSECURED CARGO IN A COLLISION. SECURE adjuster strap.
-
Page 16: Harness Features
Do not place the Baby Capsule on a table or a work-top where it could fall off. Check the Baby Capsule handle is latched properly every time you pick up the Baby Capsule, lock it onto the base or use it with a stroller. -
Page 17: Crotch Strap
Setup - Lap Strap Crotch Strap Options Lap Strap Options The capsule is fitted with two lap strap positions. This baby capsule is fitted with three LOW BIRTH WEIGHT crotch strap positions. Correct location The lap straps for an average... - Page 18 It is recommended that bulky Curved seat nappies are not used when baby is traveling in the Baby Capsule At the rear of the Capsule, Pull the shoulder strap as they can cause incorrect remove one of the harness...
-
Page 19: Lap Strap
Setup - Setting Up The Harness Setup - Setting Up The Harness Check which slot is most appropriate for the child’s Place buckle tongues into height. buckle tongue holders. Pass shoulder strap back through desired slot in cover and corresponding slot in the shell. - Page 20 Setup - Setting Up The Harness Setup -Removing Child From Capsule Press Remove all slack from Lengthen strap the lap strap area Pull (including behind Pull baby's bottom), by pulling up on the shoulder straps. Push Pull harness adjuster strap to tighten. Ensure a firm but Press comfortable fit.
- Page 21 Setup - Removing Capsule From Vehicle Setup - Removing Base From Vehicle Lengthen strap Pull Push Grab the ClickTight Disengage the vehicle Press top tether Remove top tether from handle and squeeze the seatbelt buckle. adjuster button. the capsule. button. Unthread the vehicle Lengthen top tether Lift to open the ClickTight...
- Page 22 AIRCRAFT SEATBELT PATH and thread into AIRCRAFT The Baby Capsule may not fit in smaller aircraft and cannot be label marked in green on SEATBELT PATH as shown, used with aircraft seatbelts that contain airbags unless they can both sides.
-
Page 23: Britax Strollers
Britax Strollers Aircraft The Baby Capsule base must be included with 'checked in' Attaching The Car Seat To luggage (for use after flight). Aircraft label is located on the underneath of the Baby Capsule. It demonstrates suitability for use The Stroller on aircraft. -
Page 24: Clean Harness Buckle
Care And Maintenance Care And Maintenance Regular Care Of This Restraint: Washing Care For Cover • Gentle Cold Machine Wash Please check the following items regularly to ensure the safety of • Do Not Bleach, Soak Or Wring your child. •... - Page 25 Care And Maintenance Care And Maintenance Cover (Style May Vary) Cover Remove the harness buckle from The restraint has a flame retardant cover which is removable for the underside of the capsule. Pull cleaning. Cleaning instructions are on the care label attached to each crotch strap 3-bar slide, the cover.
- Page 26 Care And Maintenance Care And Maintenance Undo the elastic bands Pull out the press studs Lift out plastic flap from Pull the seat cover and lift on the side of the capsule securing the cover to the the shell edge at the back away from the shell.
- Page 27 Care And Maintenance Care And Maintenance To Replace The Cover Pull the harness adjuster Secure press studs at side Secure elastic bands on Fit the cover onto the top strap through the cover. of seat. the side of the capsule on of seat shell and tuck into both sides.
-
Page 28: Accessories
Accessories Care And Maintenance The following instructions apply to accessories that may be ONLY USE BRITAX® SEAT COVERS AND supplied with this restraint at point of purchase. The accessories ACCESSORIES THAT ARE DESIGNED AND are for comfort use only. Use of aftermarket accessories, which are accessories not provided with this child restraint, can reduce TESTED FOR USE WITH THIS PRODUCT. - Page 29 Pull out and longer use of the capsule. attach to magnets on either Disconnect buckle and place side of the baby capsule. insert under shoulder and lap straps. To Store Drape Feed the crotch strap through...
- Page 30 Installation Of Vehicle Upper Anchor Point Installation Of Vehicle Upper Anchor Point Consult the vehicle owner’s handbook for location of anchorage Extension Straps fittings or anchorage points and the possible use of spacers. Length 300mm (Use Britax Safe-n-Sound part 0035 or 0291). Some vehicles may have an anchor fitting fitted by the vehicle Length 600mm (Use Britax Safe-n-Sound part 0036 or 0290).
- Page 31 Installation Of Vehicle Upper Anchor Point Installation Of Vehicle Upper Anchor Point Fig.2. Fig.1. IF THE CAR IS FITTED WITH A IF THE CAR IS FITTED WITH Attachment CHILD RESTRAINT UPPER A CHILD RESTRAINT UPPER Attachment Bolt IF THE CAR IS NOT FITTED ANCHORAGE POINT Bolt WITH A CHILD RESTRAINT...
-
Page 32: Installation Of Vehicle Upper Anchor Point
Installation Of Vehicle Upper Anchor Point Installation Of Vehicle Upper Anchor Point Car Installation Accessories For vehicles other than Sedans - In Australia, consult your nearest child restraint fitting station or traffic authority for vehicle (From retailers of Britax Safe-n-Sound products) ®... -
Page 33: In Case Of Accident
In Case Of Accident In Case Of Accident Crash Exchange All Britax Safe-n-Sound® child restraints are manufactured to We would never want you to experience an accident, but Australian/New Zealand Standards AS/NZS1754-2013 which require unfortunately accidents do happen. us to advise users of child restraints to "Destroy the entire restraint If you experience an accident you may be eligible for a free if it has been in use in a severe crash, even if no damage is replacement. -
Page 35: Warranty
This product may be covered by Australian and International patents and designs or pending applications. Britax Safe-n-Sound® , Safe-n-Sound® , Babylove® and Hipod® are registered trademarks of Britax® Childcare Pty Ltd. All Britax Safe-n-Sound® ,Safe-n-Sound® , Babylove® and Hipod®...
Need help?
Do you have a question about the Baby Capsule and is the answer not in the manual?
Questions and answers