Table of Contents
Advertisement
1.
Jack rear tires approximately 2" off the ground and support securely with jack stands.
2.
Sit on mower.
3.
Turn main power key to "ON". The Fuel Gauge/Hour meter should light up.
4.
Put FNR switch in FORWARD position.
5.
Put accelerator at full speed and hold. Rear wheels should be turning...
6.
Pull PTO knob up, blade motors should run and rear wheels should slow down . Turn off PTO, ensure blade
7.
motors stop.
8.
Put accelerator about ½ way down and press cruise. Cruise switch should light and wheels should continue to turn when accelerator is released.
9.
Press RMO button. RMO light should come on.
10. Put in REVERSE and press accelerator. Turn on PTO. Blades should operate while wheels turn backwards. Beeper should sound.
11. Press headlights button. Button should light and both headlights should come on.
12. Check that USB has power by verifying blue indicator light is on.
13. Remove yourself from mower seat. Beeping should be heard when there is no weight on chair. Connect charger and verify charging LEDs are working correctly (green)
14. Attempt to start mower and drive away with charger connected. This should not be possible.
Beep codes: Continuous beeping = Normal occurrence when F-N-R switch is in REVERSE condition 3 beeps = key is switched to "ON" but no operator on seat.
PRE AND POST REPAIR CHECKLIST
Confidential & Proprietary – Property of Techtronic Power Equipment – DO NOT COPY or DISCLOSE
Hide quick links:
Advertisement
Table of Contents
